Sears 486.244412 NOTE:, NOTE:, FIGURE, FIGURE, FIGURE, Tighten, Tighten, (Left Hand Side View), STEP 5: (SEE FIGURE 19), STEP 7: (SEE FIGURE 21), STEP 6: (SEE FIGURE 20)

STEP 5: (SEE FIGURE 19)

•Assemble one 5/16" jam nut (I) approximately 3/4" onto threaded end of control cable that has no rubber cap or preassembled nuts. Assemble threaded cable end through round hole in cable mount bracket and secure with another 5/16" jam nut (I). Tighten.

NOTE: Some adjustment of jam nuts may be required after blade assembly is completed.

CABLE MOUNT	3/4"
BRACKET

5/16" JAM NUT (I)

STEP 7: (SEE FIGURE 21)

•To attach the blade to the channel assembly, align the notched holes in the pivot plate with the notched holes in the blade. Insert a 1/8" x 1-1/4" cotter pin (P) down through the hole at the bend in the blade pivot shaft. Spread the ends of the pin. From the left side insert the blade pivot shaft, bend facing top of blade, through the notched holes. Secure the shaft with another 1/8" x 1-1/4" cotter pin (P) through the end hole in the shaft. Spread the ends of the pin.

•Remove the plastic cap and one 3/8" hex nut from the bolt in the blade adjust spring. Adjust the remaining 3/8" hex nut down approximately 1" onto the bolt threads. Hook the spring over the spring mount rod. Place the bolt up through the hole in the top edge of the blade and reassemble the other 3/8" hex nut to the bolt and tighten down against the top edge of the blade. Replace the plastic cap over the end of the bolt threads.

	CHANNEL ASSEMBLY	REAR


FIGURE 19	(Left Hand Side View)

STEP 6: (SEE FIGURE 20)

• Assemble ball end of control cable up through hole in

cable end fitting and pull until ball slips inside curled

edge of fitting. If ball won't slip under edge of curl, it

1/8" x 1-1/4"

COTTER PIN (P)

BLADE

PIVOT

SHAFT

PLASTIC

CAP

3/8" HEX NUT (TOP)

3/8" HEX NUT (BOTTOM)

BLADE

will need to be inserted through open end of curl.

• Assemble 1/4" x 1-1/2" (B) hex bolt down through the

cable end fitting, the 5/8" long spacer (T) and the left

hand hole in the channel assembly. Secure with a

1/4" nylock nut (J). Tighten.

NOTE: Make sure the cable mount bracket is aligned with the cable end fitting to prevent binding of cable. The other end of the control cable will be attached in a later step.

	CABLE END	1/4" x 1-1/2"
	CABLE END	HEX BOLT (B)
	FITTING	HEX BOLT (B)
	FITTING
		5/8" SPACER (T)
		CHANNEL
		ASSEMBLY

	HOLE
1/4" NYLOCK NUT (J)	REAR
	REAR

FIGURE 20

(Left Hand Side View)

		BLADE
		ADJUST
	SPRING	SPRING
	MOUNT	PIVOT PLATE
	ROD	1/8" x 1-1/4"
	ROD	COTTER PIN (P)
		COTTER PIN (P)
		NOTCHED HOLE
	FIGURE 21	(Right Hand Side View)