Sears 486.244412 INSTRUCTIONS FOR TYPE B TRACTORS, NOTE:, FIGURE, FIGURE, FIGURE, Tighten, STEP 1: (SEE FIGURE 7), STEP 2: (SEE FIGURE 8)

STEP 2: (SEE FIGURE 6)

•Attach the R.H. hanger bracket to the two front empty holes on the right side of the tractor frame using two new 3/8" x 1" hex bolts (D), 3/8" lock washers (R), and 3/8" flat washers (N) as shown. For the rear hole, use a 3/8" x 1" hex bolt (D), 3/8" lock washer (R) and 3/8" flat washer (N) with a large 1/2" washer (M) placed between the hanger bracket and the tractor frame. Tighten. Repeat for the left side.

•Proceed to INSTRUCTIONS FOR ALL 917 MODEL TRACTORS on page 8.

3/8" FLAT WASHER (N)

1/2" LARGE

3/8" LOCKWASHER (M) WASHER (R)

3/8" x 1" HEX BOLT (D)

R.H. HANGER

BRACKET

FIGURE 6

INSTRUCTIONS FOR TYPE B TRACTORS

STEP 1: (SEE FIGURE 7)

•Remove any bolts found in the holes indicated in the illustration.

REMOVE BOLTS FROM

THESE HOLES

FRONT

SUSPENSION

BRACKET

FIGURE 7

STEP 2: (SEE FIGURE 8)

• Attach the R.H. hanger bracket to the three holes shown on the side of the tractor frame using three 3/8" x 1" hex bolts (D), 3/8" lock washers (R), 3/8" flat washers (N) and 1/2" large washers (M). Use 3/8" nylock nuts (L) on inside of frame if bolts insert freely into holes. Tighten.

•Repeat for other side.

•Proceed to INSTRUCTIONS FOR ALL 917 MODEL TRACTORS on page 8.

NOTE: Use special 3/8" x 1" thread forming bolts (G) in any holes that are too small for regular bolts.

3/8" x 1" HEX BOLT (D)

(OR THREAD FORMING BOLT (G) IF NEEDED)

3/8" LOCK

WASHER (R)

3/8" FLAT WASHER (N)

3/8" NYLOCK NUT (L) (IF NEEDED)

	1/2" LARGE
R.H. HANGER	WASHER (M)
BRACKET

FIGURE 8

7