Sears 50471 Starting the Refrigerator, Use of adapter plug, Clearances, Toadiust the rollers

Use of adapter plug

Because of potential safety hazards under certain conditions, we strongly recommend against use of an adapter plugo However, if you still elect to use an adapter, where local codes permit, a TEMPORARY CONNECTION may be made to a properly grounded two-prong wall outlet by use of a UL listed adapter (Fig_ 2) available at most local hardware stores.

Starting the Refrigerator

Location

=Install the refrigerator on a floor strong enough to support it when it is fully loaded.

e Do not install it where the temperature wilt go below 60°E because it will not run often enough to maintain proper temperatures.

e Do not install it next to your range, a heating vent or where the sun will shine directly on it.

The larger slot in the adapter must be aligned with the larger slot in the wall outlet to provide proper polarity in the connection of the power

TEMPORARYMETHOD

IAOA_TERPLUOSNOT

PEtlMITTEDI_ CAIIADA	I_ _'_
AUG._GE	tl_ I

Clearances

Allow the following clearances for ease of installation,

proper air circulation, and plumbing and electrical connections:

Sides _.. 5/8" Top 1" Back 1"

cord_	t_lRMOONHECTtON
Flg, 2	BE_OR_ USE

CAUTION: Attaching an adapter ground terminal to the wall outlet cover screw does not ground the appliance unless the cover screw is metal, and not insulated, and the wal! outlet is grounded through the house wiring° You should have circuit checked by a qualified electrician to make sure the outlet is properly grounded.

When disconnecting the power cord from the adapter, always hold the adapter with one hand° if this is not done, the adapter ground terminal is very likely to break with repeated use.

Should the adapter ground terminal break, DO NOT USE the appliance until a proper ground has again been established.

Use of Extension Cords

Because of potential safety hazards under certain conditions, we strongly recommend against the use of an extension cord. However, if you still elect to use an extension cord, it is absolutely necessary that it be a UL listed 3-wiregrounding type appliance extension cord having a grounding type plug and outlet and that the electrical rating of the cord be 15 amperes (minimum) and 120 volts.

Electrical Requirements

The refrigerator should always be plugged into its own individual electrical outlet--lib volt, 60 Hertz, single phase AC. This is recommended for best performance and to prevent overloading house wiring circuits, which could cause a fire hazard from overheating wires.

(If built-in, allow 7/8" at top for hinge covers.)

Allow a 11/2" door clearance at refrigerator side, 1%" at freezer side.

Rollers

Adjustable milers behind the base grille enable you to move the refrigerator away from the "wallfor cleaning. These rollers should be set so the refrigerator rests firmly on the floor. To assure that the doors will close automatically from a halfway-open position, there is a built-intilt from the front to the back of the cabinet.

Side-by-side refrigerators also have specially designed door hinges that lift both doors slightly when opened, allowing the force of gravity to help close them securely,

Toadiust the rollers:

e Remove the base grille. Grasp it at the bottom and pull it out,

•Turn the roller adjusting screws clockwise to raise

the refrigerator, €ounter- clockwise to lower it, Use

an adjustable wrench or

pliers on the 3/8" bolts. Both doors should close

properly when bottom front edge of refrigerator cabinet is about 5/8" from the floor.

•To repnace the base

grille,	line up the	!
		I
prongs	on the grille with

the clamps on the refrigerator and push

forward until the grille snaps into place.

3