Sears 50471, 50478 warranty Automatic Bcemaker and Rce& Chilled Water Dispenser

Automatic Bcemaker and Rce& Chilled Water Dispenser

See separate Water Line Installation Requirements included in both the literature pack and on the back of the refrigerator.

An automatic icemaker and a dispenser provide chilled water, ice cubes and crushed ice through the freezer compartment door,

Here'show they work:

Water	flows	from
household		water
supply	through

a To help keep bits of ice from being sprayed beyond the glass, place glass close to ice chute--but not so close that it blocks outcoming ice_

o Do not dispense ice into thin glasses, fine china or delicate crystal--they can crack or chip from combined pressure of hand pressing them against cradle and ice dropping into container.

o Dispense ice before filling glass with soda or other beverage mixes. This wil! prevent splashing which is annoying and which, if the splash reaches the ice selector switch, could cause it to stick or bind.

(!) dual solenoid valve to

(2)water reservoir and to

(3)automatic icemaker as needed.

Water is frozen in

_L

•Beverages and foods should not be quick- chilled in the ice storage bin, Cans, bottles or food packages in the storage bin may cause the icemaker to malfunction.

= Ice other than that produced by your

icemaker should not be added to the ice

(4)cube mold and ejected into

(5)storage bin where a motor-powered auger

moves cubes forward into dispensing unit.

Cubed or crushed ice, as selected, dispense through chute in door when cradle is pressed.

When switch is moved to CRUSHED, baffle in housing channels cubes through crusher and crushed ice falls through chute into glass.

Chilled water from reservoir flows through

(6)tubing in door and is dispensed when cradle is pressed.

Pressure on cradle turns light in dispenser on, releasing pressure turns the light off°

(7)A light switch also turns night light in dispenser on and off_

Important Facts about Your Dispenser

•Your icemaker willl produce eight cubes

per cycle--approximately 120 cubes in a 24-hour

period--depending on freezer compartment temperature, room temperature, number of door openings and other use conditions°

e intermittent dispensing of ice is normal. If ice flow interruption is more than brief, ice clump(s) may be the cause and should be removed following instructions on page 11.

o Avoid overfilling glasses with ice and using

narrow or extra.tall glasses. This can jam the chute or cause the door in the chute to freeze shut_

Periodically open the freezer compartment door and look down into the chute. If ice is blocking the chute, poke it through with a wooden spool

storage bin--itmay not crush or dispense well.

Before Using Your icemaker and Dispenser

if refrigerator			is	Ice access
operated		before
				door
water	connection			is
made,				icemaker
	raise ice access
door and make			sure
icemaker		feeler	arm	is
in OFF (up) position.

_!/!!Arm	Feeler Arm
	in ON
	position

When water supply has been connected to icemaker, move feeler arm to ON (down) position.

Depress water dispenser cradle for about two minutes to remove trapped air from the water line and to fill water reservoir automatically.

The ice cube mold wilt automatically fill with water after cooling to freezing temperature, and first cubes normally freeze after several hours.

When cubes are solidly frozen, they will be ejected from the mold into the ice storage bin by means of a sweeper arm. Icemaking will continue until the feeler arm senses that there are enough cubes in the bin and halts the operation temporarily. Be sure nothing interferes with the swing of the feeler arm.

For maximum ice storage, level the stored cubes with your hand occasionally_

10