Sears 580.75151 manual Customer Responsibjlitiies, General Recommendations, Before Each USE

CUSTOMER RESPONSIBJLITIIES

iii

MAINTENANCE SCHEDULE

FiLL IN DATES AS YOU COMPLETE	HOURLY OPERATING INTERVAL
REGULAR SERVICE

MAINTENANCE TASK

PRESSURE WASHER Chock/clean inletfilter and screen

Chock high pressurehose.

Check detergent hose.

Check gun and wand for leaks.

Chock pump oil.

ENGINE

Chock oil level.

Change engine oil. _,

Service air'cleaner.

Replace/clean spark plug.

Prepare for storage.

	Every25		Every100
Before	Hours or	After First	Hours or	SERVICE DATES
Each Use	Yearly	50 Hours	Yearly

xt

X

X

X

x$

X

X_

X*_

X

Prepare unitfor storage if it isto remain idle

longerthan 30 days

1"Clean if clogged. Replace if perforated or tom

I:Change oil after first 50 operating hours, then after every 500 hours or yearly. Change oil after first 5 hours, then after every 25 hours°

* Change sooner when operating under heavy load or high ambient temperature°

GENERAL RECOMMENDATIONS

The warranty of the high pressure washer does not cover items that have been subjected to operator abuse or neg- ligence. To receive full value from the warranty, operator must maintain high pressure washer as instructed in this manual.

Some adjustments will need to be made periodically to properly maintain your high pressure washer.

All adjustments in the Service and Adjustments section of this manual should be made at least once each season.

Once a year you should replace the spark plug and clean or replace the air filter and check the gun and wand assembly for wear° A new spark plug and clean air filter assure proper fuel-air mixture and help your engine run better and last longer.

BEFORE EACH USE

,,Check engine oil level.

•Check water inlet filter and quick-connect screen for damage.

,,Check high pressure hose for leaks.

•Check detergent inlet hose and filter for damage. ,, Check gun and wand assembly for leaks.

PRESSURE WASHER MAINTENANCE

DANGER: WATER SPRAYING FROM A LEAK iS t

CAPABLE OF INJEC_NG MATERIAL INTO SKIN. NEVER REPAIR HIGH PRESSURE HOSE. RE-t PLACE WITH HOSE THAT MEETS MINIMUM PRES- t

SURE RATING OF YOUR PRESSURE WASHER, J

Check Inlet Filter and Screen: Remove quick-connect and

examine inlet screen on the female connector and filter on pump inlet fitting.Clean if either is dogged or replace if either is tom.

Check High Pressure Hose: High pressure hose can develop leaks from wear, kinking, abuse_ Inspect hose each time before using it. Check for cuts, leaks, abrasions or bulging of cover, or damage or movement of couplings. If any of these conditions exist, replace hose immediately.

Check Detergent Hose: Examine the filter'on the deter- gent hose and clean if clogged_ Hose should fit tightly on barbed fitting. Examine hose for leaks or tears. Replace the filter or hose if either is damaged.

Check Gun and Wand: Examine hose connection to gun and make sure it is secure. Test trigger by pressing it and making sure it springs back into place when you release it. Put safety latch in ON position and test trigger. You should not be able to press trigger.

Check Pump Oil: Refer to PUMP MAINTENANCE for information.

]4