![](/images/new-backgrounds/1097415/9741533x1.webp)
STORAGE
AFTER EACH USE
Water should not remain in the unit for long periods of time. Sediments of minerals can deposit on pump parts and "freeze" pump action. Follow these procedures after every
use:
Flush detergent hose by placing the injector filter into a pail of clear water while running Pressure Washer with no771e in low pressure mode. Flush for five min- uteso
Shut off the engine and let it cool, then remove all hoses.
CAUTION:"STOP" POSITIONBE SUREBEFORETHE THROTTLEYOU CONTINUELEVER . IS iNtF
YOU START THE ENGINE WITHOUT THE PROPER
WATER SUPPLY CONNECTED, YOU CAN DAM- AGE THE PUMP.
•Empty the pump of all pumped liquids by pulling recoil handte about 6 times. This should remove most of the
liquid in the pump.
oCoil the high pressure hose and inspect it for damage. Cuts in the hose or fraying of it could result in leaks and loss of pressured Should any damage be found, replace the hose. DO NOT attempt to repair a damaged hose and use it, Replace the hose with the genuine Crafts- man part.
•Drain water from hose and properly hang it on the wire support provided on the guide handle
NOTE: To protect the unit from freezing temperatures, you can draw windshield washer fluid into the pump by pouring the washer fluid into a
nected to the inlet adapter and pulling the recoil handle twice_
o Store in a clean, dr,/area.
LONG TERM STORAGE
WARNING: NEVER STORE ENGINE WITH FUEL iN
TANK INDOORS OR IN ENCLOSED, POORLY VEN- TILATED AREAS WHERE FUMES MAY REACH AN
OPEN FLAME, SPARK OR PILOT LIGHT AS ON A FURNACE, WATER HEATER, CLOTHES DRYER OR OTHER GAS APPLIANCE,
If you do not plan to use the Pressure Washer for more than 30 days, you must prepare the engine for long term storage.
NOTE: As always, prepare the pressure washer pump as you would after each use°
It is important to prevent gum deposits from forming in essential fuel system parts such as the carburetor, fuel filter, fuel hose or tank during storage_ Also, experience indicates that
To avoid engine problems, the fuel system should be
emptied before storage of 30 days or Ionger_ Follow these instructions:
Protect Fuel System: Engines stored over 30 days need to be protected or drained of fuel to prevent gum deposits from forming in fuel system or on essential carburetor parts.
°For en_i_e protection use a fuel stabilizer (such as
engine for short time to circulate stabilizer through carburetor.
-If you did use "gasohol", run engine until engine stops from lack of fuel. Make sure you have water supply to pump inlet connected and turned ONo
Change Oi1: While engine is still warm, drain oil from crankcase. Refill with recommended grade_
Oil Cyllnder Bore: Remove spark plug and pour about 1/2 ounce (15ml) of engine oil into the cylinder. Cover spark plug hole with rag. Crank slowly to distribute oil
I .,_ CAUTION' AVOIDSPRAYFROMSPARKPLUG
HOLE WHEN CRANKING ENG,NE SLOWLY.
o Install spark plug.. Do not connect spark plug wire.
OTHER
oDo not store gasoline from one season to another.
°Replace your gasoline can if your can starts to rusL Rust and/or dirt in your gasoline will cause problems.
otf possible, store your unit indoors and cover it to give protection from dust and dirt,
oCover your unit with a suitable protective cover that does not retain moisture.
IMPORTANT: NEVER COVER YOUR PRESSURE WASHER WHILE ENGINE AND EXHAUST AREAS ARE
WARM,
/7