Sears 625.34823 Holding Clips Into PLACE, from the TOP, Down AS SHOWN. be Sure They Snap Firmly

I SECTION 3 STEP BY STEP GUIDES TO INSTALL

I

L	BYPASS VALVE ITEM NO. 42/65-3437 - If not
D. already done, put a light coating of silicone grease
	or Vaseline on the bypass valve o-rings.
Push the bypass valve into the filter valve as far as
it will go (FIG. 5, 6 and 7). SNAP THE 2 LARGE			TURN BYPASS VALVE
HOLDING CLIPS INTO PLACE, FROM THE TOP			UPStDF.- DOWN TO
			CONNECT TO FLOOR
DOWN AS SHOWN. BE SURE THEY SNAP FIRMLY
		IN	LEVEL PLUMBING

IN PLACE, SO THE BYPASS VALVE WILL NOT

PULL OUT. GO TO STEP 7.

SIDE VIEW END VIEW

/_-_CLIP

			Valve Body	Of
			ntet or Out_et	Bypass Venire
				(Push all the way in)
6, INSTALLING	3 VALVE BYPASS, OR SEARS		INSTALLING BYPASS VALVE
			ITEM	NO. 42/65-3436, OR
BYPASS VALVE, ITEM NO. 42/65 3436, AND			3-VALVE BYPASS
PIPES (FIG.	8).
Cut the house main water pipe where you wilt		SINGLE	VALVE BYPASS	3-VALVE BYPASS
a, connect the filter. Loosely put together pipe, fit-
tings, and the 3 valves or Sears special bypass
valve. Place valve(s) within easy reach.
IMPORTANT: WHEN LOOKING AT THE FRONT OF
THE FILTER, THE INLET IS ON THE RIGHT SIDE.
IF WATER IN YOUR HOUSE MAIN WATER PIPE
RUNS FROM LEFT TO RIGHT, BE SU RE TO USE A			Filter
_CROSS-OVER"	AS SHOWN IN FIG. 2 AND 3,			FiRer
PAGE 8.				inlet

If all pipe, fittings and valves fit together good, b, tighten all threaded joints (use pipe dope on

outside threads), or solder atl joints following the soldering tips on page 20.

10