Sears 625.34823 specifications Step by Step Guides to Install, Small Parts BAG Items

I SECTION 3 I STEP BY STEP GUIDES TO INSTALL

	Close the shut-off valve on the house main water	Shutoff	Shutofl	Pressure
• I.
	pipe, near the water meter or pressure tank, to Valve		Valve	Tank
turn	off the water.
		Meter	Pump	I'

r-_. Shut off the gas or electric supply to the water heater.

•3. Open the highest and lowest water faucets in your house to let water drain from the pipes.

Close faucets after water has drained.

Take all the small parts from the parts bag and

4.lay out neatly where you can easily see and get to them as they are needud.

NOTE: The inlet screen is not used on the clarifying filter, and can be discarded.

Electrical

Gas

Valve

Panel

SMALL PARTS BAG ITEMS

(_) SCREENINLET _'_ _ADAPTORNLET-OUTLET(2)CLIP (2)

(-_WASHER OR O _J GASKET (2)

GROUND

CLAMP (2)	_ I] NLET.OUTLET
___________	TUBE (2)

TRANSFORMER

_INL_r-OUTLE¢

_ _ NUT (2)

® _ GROUNDWIRE,

_, Q= SCREWS AND NUTS

5, INSTALL INLET AND OUTLET ADAPTORS OR

SEARS BYPASS VALVE, ITEM NO. 42/65-3437.

NOTE: If you will install the bypass valve, the adap- tors are not used. If you do not install the bypass valve, you must use the adaptors.

INLET AND OUTLET ADAPTORS (Adaptors am and clips are small parts bag items.) - Push the

adaptors into the valve inlet and outlet ports (FIG. 5 and 7) as far as they will go. Both adap- tors are the same and fit either valve port. SNAP

THE 2 LARGE HOLDING CLIPS INTO PLACE, FROM THE TOP DOWN AS SHOWN. BE SURE THEY SNAP FIRMLY INTO PLACE, SO THE

ADAPTORS WILL NOT PULL OUT...GO TO STEP 6.

INSTALLING INLET AND OUTLET

ADAPTORS OR BYPASS VALVE

Clips (2)

	Adaptors
SEALS	//4
PLACED tN	OR
ONLY. CLIP SNAPS	P/
INTO INNER GROOVES
(SEE FIG. 7)

9