Humidifier Operations

Your new Sears humidifier is designed to
satisfy home humidity requirements
through the principle of evaporation of
water in the air.
After water is added to the bottle, the fil-
ters begin to soak up the water and
become totally saturated in approximately
30 minutes. Air is drawn infrom the rear of
the humidifier and through the filters by
means of circulation fans. As air passes
through the filters, moisture is absorbed
into the air and then released in the form
of vapor. No water droplets will enter the
home. All evaporation into the air takes
place in the humidifier, which means that
the residue left by evaporating water is not
passed into the home, but remains in the
filter.
CAUTION: Use only 42-14900 EPA
Registered Bacteriostat available
from SEARS Retail store. Under no
circumstances should you use water
treatment products designed for Roto
belt or Ultrasonic humidifiers.

Assembly

Your new Sears Kenmore humidifier is com-
pletely assembled fer you to use. Remove
the packaging material from inside your
humidifier and follow the instructions of this

Location Instructions

WARNING: For your own safety, do not I
use humidifier if any parts are damaged
or missing.
Step 1
Place humidifieron aflat level surface in an
area of house where mosthumidity isneed-
ed, or one which would likely result in moist
air being circulated throughout the house,
such as near acold air return.
Placing the unit level isvery important if the
humidifieris located on carpeting.
NOTE: The 13 gallon humidifier contains
water bottles. The weight ofthe bottles in
thefront ofthe cabinet may cause the front
Humidified Air is
Then Released
Through the Top
ii'f,liil
Dry Air Enters
CAUTION: To reduce the risk of injury,
fire or damage to humidifier, use only
cleaners specifically recommended
for humidifiers. Never use flammable,
combustible or poisonous materials to
clean your humidifier. To reduce the
risk of scalds and damage to humidifi-
er, never put hot water in humidifier.
owner's manual for proper usage. The
packaging material is located under the fan
assembly. Remove the packaging material
and discard.
castersto sink deeper into the carpet. Ifthis
happens, the water level will be higher
towards the front of the humidifier, and
lower towards the back. The water level
float(located at the rear of the cabinet) may
notsense the water so the fill light will be on
and the unit will not energize. If this hap-
pens, the unit will need to be leveled in
order for the humidifier to be energized, it
may be necessary to purchase leveling
coasters from your local hardware store.
The coasters should be positioned under
the front two casters of the humidifier.
4