Troubleshooting
Trouble
Unit will not run.
Unit will not shut off.
Unit will not dry out completely
I Bottles continue to empty.
Probable Cause
•Humidity level is too high
•No power
•Float is not free
•Water is present in the system
•High humidity or low temperature resulting in slow evaporation
•Air is entering water reser- voirs.
Remedy
• Raise humidistat setting |
• Check 120 volt power source |
• Free float from obstruction |
• This is normal. A small |
amount of water remains in |
the cabinet. |
• Allow unit to continue opera- |
tion. |
• Check |
ensure tightness. |
• Check for leak in water bottles. |
• Are gaskets for |
Caps" in place (see repair |
parts list). |
Unit is not emptying. • Dirty filter
•Reservoir cap plunger missing post in bottom of cabinet.
• | Change | to a fresh | new filter. | |||
• | Check | orientation of bottle. | ||||
| Reposition | so | that | reservoir | ||
| cap | plunger | is | depressed by | ||
| post | in bottom | of cabinet. | |||
Unit runs and shuts off before bottles are empty
!• Humidity level is too high
•Unit is not setup on a level surface (Float will not sense water at the rear of the cabinet.
• Raise humidistat setting (if |
possible) |
• Position unit level (Some car- |
pet padding may allow unit to |
set lower in the front than the |
rear with the additional weight |
of water bottles in the front of |
the cabinet. Install coasters |
under front casters. |
CAUTION: Use only
Sears Retail store.
Use of other water treatment products may damage the filter elements.
Under no circumstances should you use water treatment products designed for Roto belt or Ultrasonic humidifiers.
13
