Sears 758.144533 owner manual Water Fill

Water Fill (continued)

Notice the water bottles are designed as right and left hand units. Position them in the correct location so the humidifier can

function properly. The water bottles should rest in the front of the cabinet.

Each "E-Z-FillSide-Cap" must be facing the rear of the unit.

Each water bottle is designed with an "E-Z-Fill Side-Cap" that is easily remov- able. Remove the "E-Z-Fill Side-Cap" on the side of the water bottle by twisting counterclockwise.

Place the opening of the water bottle under a water faucet (the bottle should fit under a four-inchclearance faucet). Fill with recom- mended mixture of cold water and Sears Bacteriostat #42-14900 only. Solid debris could make the valve leak.

Install the "E-Z-Fill Side-Cap" by twisting clockwise. Hand tighten only.

Check for possible leaks by performing the following:

1.Grasp bottle handle and hold the bottle upright over a sink.

2.Press up on valve cap plunger for about one second to let out a little water.

3.Release the plunger.

4.Listen for air bubbles. Look for leaks around =E-Z-FillSide-Cap".

5.If you _ear air bubbles or see leaks,

retighten "E-Z-FillSide-Cap" and repeat steps 1-4.

Wipe off excess water from the bottle.

Position the water bottle back into the unit. Grasp the water bottle handle, and lower into the cabinet until the bottle sits on pads at bottom of cabinet. The "E-Z-Fill Side-Cap" must be facing the rear of the cabinet. When positioned properly, the plunger will open and water will flow into the cabinet. The water level will automati-

cally re_ at approximately 1/2" until the bottles are empty.

The unit is now ready for operation.

Rear of

Humidifier

"E-Z-FillSide-Cap" Should Always

Face Rear

Turn Counterclockwise

to Remove Cap

' Valve

Cap Plunger

Pivoting Lid Removed ) /

for Clari_

°

6