Sears 790.9375 Setting Warmer Drawer Controls, Removing, Replacing, Warmer Drawer If equipped

Setting Warmer Drawer Controls

	Removing	and	Replacing	Warmer Drawer (If equipped)
	Pullup with flr_-,er	To Remove and Replace Warmer (Warm & Ready TM) Drawer
[]		To Remove Warmer Drawer:
		1.	_	Turn power off before removing the warmer drawer.

2.Open the drawer to the fully opened position.

3.On the right glide you will find a shield attached with a hex-head screw (see figure 1). Using a 1/4" socket and ratchet remove the shield.

4.Locate glide lever on each side of drawer, pull up on the left glide lever and push down on the right glide lever.

5.Pull the drawer away from the range.

Removeshieldon rigl glide. Pullup on left le_er while pushingdowno_

Pu=hdown with fli'_er

Figure I

To Replace Warmer Drawer:

1.Replace shield on the right glide of the drawer body.

2.Pull the bearing glides to the front of the chassis glide (see figure 2).

3.Align the glide on each side of the drawer with the glide slots on the range.

4.Push the drawer intothe range until levers "click" (approximately 2"). Pull the drawer open again to seat bearing glides into position. If you do not hearthe

levers "click" or the bearing glides do not feel seated remove the drawer _,,C_ and repeat steps 2-4. This will minimize possible damage to the bearing

glides.

NOTE: The Warmer Drawer wi!!NOT operate while inthe Self-C!ean and ,Qven ,._,_ Lockout" modes

serious injury or death. Disconnect appliance from electric power before cleaning Electricaland servicingShocktheHazardwarmercandraweroccur. and result in

Figure 2

15