Sears 831.159231 owner manual Operation and Adjustment, Changing the Weight Setting of the System

15. Separate the ends of the Conirol Stand (29) and slide

15

the Plastic Sleeve (30) onto one end. Bring the ends tOgether and _enter the Plastic Sleeve between them.

Plug one end	of the Control		Cord	(27)	into the Hand	27
Control (28).	Plug	the other	end	of the	Cord into the
Wire Adapter	(74)	at the front of		the system.

Attach the Hand Control (28) to the Control Stand (29) with the two 1/2" Tap Screws (31).

Plug the Power Cord (26) into the socket at the back- of the system.

OPERATION AND ADJUSTMENT

Plug the transformer on the power cord into a 120-vott outlet. Keep the power cord away from walkways and heated surfaces. Turn on the power when using the system, or the system could be damaged. When you are finished using the system, always unplug the transformer.

DIAGRAM OF THE HAND CONTROL
				I,	Il-iJ.'1_3 t" m l	I
1. Low/High Range IndicatornShows			when the system is
set at minimum or maximum		weight.		1		2
2. Weight Display--Displays	the	current weight		setting.	!'''L "UII
				3--		5

3.Power Button--Turns the power on and off.

4. Weight Decrease Button--Decreases the weight. 4--

5.Weight Increase Button--Increases the weight.

TURNING ON THE POWER AND RESE'n'ING THE SYSTEM

Press the power button. IMPORTANT: Each time the power is turned on, the system must be reset

before the weight can be changed. The weight display will read "E--." To reset the system,

press the weight increase or decrease buttons until the display reads "H250" (maximum weight) or "L30" (minimum weight).

CHANGING THE WEIGHT SETTING OF THE SYSTEM

The weight can be changed from a minimum of 30 pounds, up (0 a maximum of 250 pbunds, in incre- ments of 1 pound. To increase the weight, press the weight increase button. To decrease the weight, press the weight decrease button. The buttons can be held down to change the weight quickly. IMPORTANT: To prevent damage to the system, do not put any tension on the system while changing the weight. Do not push onthe butterfly arms, ab arm or leg lever, if the lat bar is attached to the system, it may be helpful to support the weight of the lat bar with one hand. The system motor will emit a sound to alert you while the weight Is being changed.