ASSEMBLY
Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Read all steps carefully before beginning. See the PART I.D.
CHART accompanying this manual for a drawing of each small part used In assembly and for a list of the tools needed. The assistance of a second person is recommended.
Press the four 2" x 2" Outer Caps (13) onto the Stabilizer (2). Turn the Stabilizer so the indicated bracket is on top. Insert the four 3/8" x 2 1/2" Carriage Bolts (87) up through the Stabilizer as shown.
Place the Frame (1) over the two indicated 3/8" x
2 1/2" Carriage Bolts (87) as shown. Finger tighten two 3/8" Nuts (89) with 3/8" Lock Washers (88) onto the Carriage Bolts.
, | , | ' | ,, |
;. @-89 13-t_
" J_"88
13 Bracket_.._!/. "_,
.
.
.
Remove the 3/8" x 3/4" Bolt (35), the Cable Hook "(48), the extra washer (A), and the 3/8" Nylock Nut (6) which secure the Lower Cable (76) to the Frame (1) as shown in the inset. Do not release the Cable until completing this assembly step. The 3/8" x 3/4" Bolt (35) and the 3/8" Nylock Nut (6) will be used in assembly step 3 below. The Cable Hook will be used later. The extra washer should be discarded.
Lower Cable (76) under the Pulley. Attach the Pulley to the Stabilizer (2) with a 3/8" x 1 3/4" Bolt (18) and
3/8" Nylock Nut (6) as shown. Do not overtighten the Nut. The Pulley should turn freely.
Attach the Foot Plate (34) to the Frame (1) with the two 3/8" x 3/4" Bolts (35) and two 3/8" Nylock Nuts (6).
Press the Backrest Post (63) at the lower end of the Backrest (36) into the Frame (1) as shown. Attach the upper end of the Backrest to the Frame with the 1/4" x 2 1/2" Bolt (37) and a 1/4" Lock Washer (7).
............. |
| 87 |
2 |
| ' I |
/ | i | |
| 7e', % |
-
