ASSEMBLY
Set the treadmill in a cleared area and remove all packing matedals. Do not dispose of the packing materials until
assembly is completed.
THE FOLLOWING TOOLS ARE REQUIRED FOR ASSEMBLY: The Included 7/32" allen wrench
and your own adjustable wrench _ | . |
1.Raise the Right Handrail (12) to a vertical position. Align the hole in the lower end of the Right Handrail with the h01e in the side of the Frame (36). Insert one of the three 3/8" x 2" Bolts
(28)into th e Right Handrail, and tighten the Bolt into the Frame. Tighten the Bolt that is already in the Right Handrail.
Tighten
Press the Right Handrail Cap (27) onto the lower end of the
Right Handrail (12). Note: It may be necessary to push the 12"
Cable Loom (10) into the Right Handrail.
2. Using the | 7/32" Allen Wrench | (9), loosen the Handrail Bolt that is | 2 | 1 | 38 | |
under the | Console (6). Rotate | the Console to the position | ||||
|
|
|
shown.
See the inset drawing. If there is a cable tie through the Handrail
(1)and Handrail Cage Nut (38), cut it. Make sure that the Cage Nut is inserted into the hole in the underside of the Handrail.
Insert the upper end of the Left Handrail (1) into the left side of the Console (6). Insert a Handrail Bolt (2) into the bottom of the Console and the Left Handrail (1). Finger tighten the Handrail Bolt.
3.Align the holes in the lower end of the Left Handrail (1) with the holes in the treadmill Frame (36). Tighten a 318" x 2" Bolt (28) into each hole.
Press the Left Handrail Cap (68) onto the lower end of the Left Handrail (1).
See step 2. Using the 7/32" Allen Wrench (9), tighten the two Handrail Bolts (2) under the Console (6).
28 1 36
4.Remove the paper backing from the Wrench Clip (16). Press the
Wrench Clip onto the Right Rear Endcap (59) in the indicated lo- cation. Press the 3/16" Allen Wrench (58) into the Wrench Clip.
Make sure that all parts are tightened before using the treadmill.
Note: To protect the floor or carpet from damage, place a mat under the treadmill.
_59
16
6
