ERVmCEAN ADJUSTMENTS
TO ADJUST STEERING WHEEL ALIGNMENT
If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straightforward, remove steer-
ing wheel and reassemble per instructions in the Assembly section of this manual
FRONT WHEEL TOE-IN/CAMBER
The front wheel
TO REMOVE WHEEL FOR REPAIRS
(See Fig. 26)
•Block up axle secure{y,
°Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not Iose)_
•Repair tire and reassemble°
°On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.
•Replace washers and snap retaining ring securely in axle groove.
•Replace axle cover.
WASHERS
TO START ENGINE WITH A WEAK BATTERY
See Fig. 27)
_u=_,,, _
CAUTION;
and smoking materials away from bat- teries. Always wear eye protection when around batteries.
If your battery is too weak to start the engine, it should be
recharged° If "jumper cables" are used for emergency starting, follow this procedure:
IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12
VOLT NEGATIVE GROUNDED SYSTEM THE OTHER
VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED SYSTEM, DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES_
TO ATTACH JUMPER CABLES -
oConnect each end of the RED cable to the POSITIVE
(+)terminal of each battery, taking care not to short against chassis,
=Connect one end of the BLACK cable to the NEGA- TIVE
°Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery
TO REMOVE CABLES, REVERSE ORDER -
=BLACK cable first from chassis and then from the fully charged battery.
°RED cabte last from both batteries,
RETAINING RING
AXLE COVER
1
_"SQUARE KEY
(REAR WHEEL ONLY)
FIG. 26
POSITIVE TERMINAL | NEGATIVE TERMINAL |
CHASSIS
CABLES
CHARGED
BATTERY
POSITIVENEGATIVE
TERMINALTERMINAL
FIG. 27
23
