TROUBLESHOO NG POINTS
CAUSECORRECTION
Engine continues to | run | 1.. | Faulty | |||||
when | operator | leaves | seat |
|
|
|
|
|
with | attachment | clutch |
|
|
|
|
| |
engaged |
|
|
|
|
|
|
| |
Poor cut - uneven |
| 1. | Worn, | bent | or loose blade.. | |||
|
|
|
| 2 | Mower | deck | notlevel. | |
|
|
|
| 3 | Buildup of grass, | leaves, and trash under mower | ||
|
|
|
| 4 | Bent blade | mandrel | ||
|
|
|
| 5.. | Clogged mower | deck vent holes from buildup of | ||
|
|
|
|
| grass, leaves, and trash around mandrels | |||
Mower blades | will not | 1 | Obstruction | in clutch mechanism | ||||
rotate |
|
| 2 | Worn/damaged | mower drive belt. | |||
|
|
|
| 3. | Frozen | idler pulley | ||
|
|
|
| 4 | Frozen | blade mandre! | ||
wit
1Check wiring, switches and connections, If not corrected, contact an authorized service facility
1Repiace blade. Tighlen blade bolt.
2Level mower deck
3Clean underside of mower'housing
4Replace blade mandrel
5Clean around mandrels to open vent hoies
t Remove obstruction
2Replace mower drive bait
3Replace idler pulley.
4Replace blade mandrel
Poor grass discharge
Headlight(s) not working (if so equipped)
!., Engine speed too slow
2Travel speed too fast
3Wet grass,
4.Mower deck not level
5, Lowtuneven tire air pressure 6 Worn, bent orloose blade
7..Buildup of grass, leaves and trash under mower
8Mower drive beltworn..
9Btades improperly installed
10 Improper blades used.
11.Clogged mower deck vent holes from buildup of grass, leaves, and trash around mandrels
ww...........
t Switch is "OFF"
2Bulb(s) burned out..
3Faulty light switch..
4.Loose or damaged wiring
5.Blown fuse
1Place throttle controf in "FAST" position.
2Shift to slower speed.
3Allow grass todry before mowing..
4Level mower deck
5Check tires for proper air pressure.
6Replace/sharpen blade.. Tighten blade bolt.
7Clean underside of mower housing,
8Replace mower drive bett
9 Reinstall blades sharp edge down
10 Replace with blades listed in this manual,
1t Clean around mandrels to open vent holes
1 Turn swilch "ON".
2Replace bulb(s).
3Check/replace light switch..
4Check wiring and connections
5 Replace fuse.
Battery will not charge | 1 | Bad battery | cell(s) | |
| 2. | Poor cable | connections | |
| 3.. | Faulty | regulator (if so equipped). | |
| 4. | Faulty | alternator. | |
Engine "backfires" | 1,. | Engine | throttle control not set at "SLOW" | |
| ||||
when turning engine |
| position for | 30 seconds before stopping engine | |
"OFF" |
|
|
|
|
t Replace battery
2Check/clean all connections
3Replace regulator
4.Replace alternator
1.Move throttle control to "SLOW" position and attow to idle for 30 seconds before stopping engine
28
