OPERATmON
The operation of any tractor can result in foreign objects thrown into the eyes, which can result
G_SSE_ in severe eye damage. Always wear safety _llasses or eye shields before starting your tractor and while moving. We recommend Wide Vision Safety Mask for over the spectacles or standard safety glasses.
HOW TO USE YOUR TRACTOR
TO SET PARKING BRAKE (See Fig. 9)
oDepress clutch/brake pedal into full "BRAKE" position and hold
Place parking brake lever in "ENGAGED" position and release pressure from clutch/brake pedal. Pedal should
remain in "BRAKE" position_ Make sure parking brake will hold vehicle secure.
STOPPING (See Fig. 9)
MOWER BLADES -
°Move attachment clutch lever to "DISENGAGED" po- sition_
GROUND DRIVE -
•Depress clutch/brake pedal into full "BRAKE" position ° Move gearshift lever to "NEUTRAL" position_
ENGINE -
Move throttle control to "SLOW"position
NOTE: Failure to move throttle control to "SLOW" position and allowing engine to idle before stopping may cause engine to "backfire"
•Turn ignition key to "OFF" position and rernove key.
Always remove key when leaving vehicle to prevent unauthorized use.
•Never use choke to stop engine
NOTE: Under certain conditions when unit is standing idle with the engine running, hot engine exhaust gasses may cause "browning" of grass. To eliminate this possibility, always stop engine when stopping unit on grass araas_
I | _ | CAUTION: Always stop unit | completely, | |
| _k | as described | above, before | leaving the |
|
| operator's position; to empty grass | ||
|
| catcher, etc. |
| I |
|
|
|
| i |
TO USE THROTTLE CONTROL (See Fig. 9)
Always operate engine at full throttle
•Operating engine at less than full throttle reduces the battery charging rate,
•Full throttle offers the best bagging mower perfor- mance_
TO MOVE FORWARD AND BACKWARD
(See Fig. 9)
The direction and speed of movement is controlled by the gearshift lever.
. Start tractor with clutch/brake pedal depressed and gearshift lever in "NEUTRAL" position_
. Move gearshift lever to desired position_
•Slowly release clutch/brake pedal to start movemenL
IMPORTANT: BRING TRACTOR TO A COMPLETE STOP BEFORE SHIFTING OR CHANGING GEARS. FAILURE TO DO SO WILL SHORTEN THE USEFUL LIFE OF YOUR TRANSAXLE_
ATTACHMENT
CLUTCH LEVER "ENGAGED"
THRO!"rLE/CHOKEPOSITION
CONTROL
"DISENGAGED"
POSITION
PARKING BRAKE
"ENGAGED'POSITION
"BRAKE"
POSITION
"DISENGAGED"
POSITION
HEIGHT
ADJUSTMENTKNOB
CLUTCH/BRAKE PEDAL "DRIVE" POSITION
FIG. 9
TO ADJUST MOWER CUTTING HEIGHT
(See Fig. 9)
The cutting height is controlled by turning the height ad- justrnent knob in desired direction_
=Turn knob clockwise to raise cutting height
=Turn knob counterclockwise to lower cutting height.
The cutting height range is approximately
oThe average lawn should be cut to approximately
=For best cutting performance, grass over 6 inches in height should be mowed twice Make the first cut relatively high; the second to desired heighL
12