ill | i | illl ,,i,i | ii |
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 38)
•Raise hood,.
•Unsnap headlight wire connector,.
°Stand in front of tractor, Grasp hood at sides, tilt toward engine and lift off of tractor.
°To replace, reverse above procedure.
WIRE
CONNECTION
HOOD
...............i | iiil,,ll | ii i iilllllllllllllll | i |
ADJUSTMENTS
Hi,uui lllllllll | i t |
QUARTER | _ "s_ \ \ | ) |
FIG. 38
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
(See Fig. 39)
The throttle control has been preset at the factory and adjustment should not be necessary, Check adjustment as
described below before loosening cable,, if adjustment is necessary, proceed as follows:
•With engine not running, move throttle control lever to "FAST" position.,
°Check that swivel is against side of quarter circle. If it is not, loosen cable clamp screw and pull cable back until swivel is against quarter'circle° Tighten cable clamp screw securely.,
TO ADJUST CHOKE CONTROL (See Fig. 40)
The choke control has been preset at the factory and adjustment should not be necessary. Check adjustment as described below before loosening cable. If adjustment is necessary, _proceed as follows:
°With engine not running, move choke control (located on dash panel) to full "CHOKE" position°
°Remove air cleaner cover, filter and spitback plate to expose carburetor choke (see "AIR FILTER" in main- tenance section).
°Choke should be closed. If it is not, loosen casing clamp screw and move choke cable until choke is completely closed, Tighten casing clamp screw se- curely.
°Reassemble air cleaner.
FIG. 39
CHOKECLOSED
CHOKE
LEVER
CASING
CLAMP
SCREW
FIG. 40
24
