ASSEMBLY
,,,1111111..............
INSTALL MOWER AND DRIVE BELT (See Fig. 5 and 8)
Be sure tractor is on level surface,, Engage parking brake.
oCut and remove tie down wire between
and Roll,, gauge wheel brackeL Swing
oSlide mower under tractor with discharge guard to right side of tractor.
°Install one front link in LH. front mower bracket and
Loll,,front suspension bracket. Retain with two single loop retainer springs as shown,
oSlide right side of mower deck forward, toward RoHo front tire.
°Check belt for proper routing in all mower pulley grooves,, Install belt into engine pulley groove°
°Install second front link in Roll, front mower bracket and
RoH. front suspension bracket° Retain with two single loop retainer springs as shown.
°Turn height adjustment knob counterclockwise until it stops, Lower mower linkage with attachment lift lever.,
°Place the suspension arms on deck pins and retain with double loop retainer springs°
CHASSISSUSPENSION
BRACKET
DOUBLE LOOP
RETAINER SPRING
BOLT
•Connect
oTurn height adjustment knob clockwise to remove slack from mower suspension
•Raise deck to highest position,,
•Insert gauge wheels as shown using long shoulder bolts and nuts,,Tighten securely,
CHECK DECK LEVELNESS
For best cutting results, mower housing should be properly leveled. See "TO LEVEL MOWER HOUSING" in the
Service and Adjustments section of this manual
CHECK FOR PROPER POSITION OF ALL BELTS
See the figures that are shown for replacing motion, mower drive, and mower blade drive belts in the Service and
Adjustments section of this manual., Verify that the belts are routed correctly,,
| SINGLE LOOP |
| |
| RETAINER SPRINGS | FRONT | |
FRONT MOWER |
| SUSPENSION | |
| BRACKET | ||
BRACKET | FRONT | ||
| |||
SINGLE | LINKS |
| |
LOOP |
| ELECTRIC | |
RETAINER |
| ||
| CLUTCH | ||
SPRINGS |
| ||
|
| PULLEY |
FRONT
SUSPENSION
BRACKET
SINGLE
LOOP RE3rAINER
SPRINGS
MOWER
BRACKET
| ||
| BAR |
|
| DOUBLE | LOOP |
NUT | RETAINER | SPRING |
|
|
GAUGE
WHEEL
DISCHARGE
GUARD
FIG. 5
9