SERVICE AND ADJUSTMENTS
TO REPLACE MOWER BLADE DRIVE BELT
(See Fig, 23)
The mower blade drive belt may be replaced without tools. Park the tractor on level surface. Engage parking brake.
BELT REMOVAL -
•Remove mower from tractor (See "TO REMOVE MOWER" in this section of this manual).
•Work belt off both mandrel pulleys and idler pulleys. ° Pull belt away from mower.
BELT INSTALLATION
, Install new belt in reverse order of removal.
•Make sure belt is in al! pulley grooves and inside all belt guides.
Install mower in reverse order of removal instructions_
MANDRELIDLER
PULLEYPULLEYS
MANDREL
PULLEY
FIG. 23
TO ADJUST BRAKE (See Fig. 24)
Your tractor is equipped with an adjustable brake system which is mounted on the right side of the transaxle.
If tractor requires more than six (6) feet stopping distance at high speed in highest gear, then brake must be adjusted.
°Depressclutch/brakepedalandengageparkingbrake.
°Measure distance between brake operating arm and nut "A" on brake rod.
JIfdistance is other than
oRoad test tractor for proper stopping distance as stated above. Read ust if necessary. If stopping distance is still greater than six (6) feet n highest gear, further maintenance is necessary. Contact your nearest au- thorized service center/department.
WITH PARKING BRAKE "ENGAGED"
NUT "A"
JAM NUT
FIG. 24
TO REPLACE MOTION DRIVE BELT
(See Fig. 25)
Park the tractor OR level surface. Engage parking brake°
For assistance, there is a belt installation guide decal on bottom side of left footrest.
•Remove mower (See "TO REMOVE MOWER" in this section of this manuaL)
oRemove upper belt keeper.
°Remove belt from stationary idler and clutching idler.
°Pull belt slack toward rear of tractor. Remove belt
upwards from transaxle pulley by deflecting belt keep-
ers,
°Pull belt toward front of tractor and remove downwards from around engine pulley.
°Install new belt by reversing above procedure°
IMPORTANT: MAKE SURE UPPER BELT KEEPER IS POSITIONED PROPERLY BETWEEN LOCATOR TABS,
ENGINE
PULLEY
CLUTCHING
IDLER TASS LOCATOR
STATIONARY | |
,OLER | I |
TRANSAXLEII -I1, It KEEPERUPPER BELT
FIG. 25
23