Sears 917.29425 owner manual Engine, To Adjust Carburetor

• To maintain the superb tilling perfor-

mance of this machine the tines should			tine_3
be checked for sharpness, wear, and
bending, particularly the tines which
are next to the transmission. If the gap
between the tines exceeds 3-1/2 inches
they should be replaced or straightened
as necessary.
• New tines should be assembled. Sharp-		Tine	Tine
ened tine edges will rotate rear
		3-1/2" Max
		Hairpin Clip
			Hairpin Clip
Counter Tine
Rotation			Sharp Edge
	Sharp Edge
0205	0

Sharp Edge

Shear Pin Sharp Edges

Shear Pin

tine_13

ENGINE

Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the customers ex- pense, may be performed by any non-road engine repair establishment or individual. Warranty repairs must be performed by an authorized engine manufacturer's service outlet.

TO ADJUST CARBURETOR

The carburetor has been preset at the factory and adjustment should not be necessary. However, engine performance can be affected by differences in fuel, tem- perature, altitude or load. If the carburetor does need adjustment, contact your near- est Sears or other qualified service center.

IMPORTANT: Never tamper with the engine governor, which is factory set for proper engine speed. Overspeeding the engine above the factory high speed setting can be dangerous. If you think the engine-governed high speed needs adjusting, contact your nearest Sears or other qualified service center which has the proper equipment and experience to make any necessary adjustments.

17