TROUBLE SHOOTING
|
| L, | ,,! |
|
PROBLEM |
| CAUSE |
| |
=, | __J | LI= |
| ,_ |
1, Doesn't | draw | . | Chemical control knob not open far | |
chemioalldeter. |
| enough or too far open | ||
gent like it |
|
|
| |
should |
| ,, | Chemical/detergent | not thinned |
|
|
| enough |
|
|
| . | Chemicalldetergent | not proper type |
|
|
| for suction use. |
|
q Water control knob "ON"
,,,,,, | ii | ii | • |
2. Sputters when | • Chemical | control knob open too far |
spraying chemical/ detergent
LLI
GUIDE
CORRECTION
, | ,,_,, |
•Open knob gradually until you achieve desired flow rate (2_ turns maximum)
•Add water to thin the solution
•Use Sears speoial oleanerldegreaser
•Turn water control knob "OFF" Only air and chemical Control knobs
should be "ON"
Ju_,uu
• Close knob until sputter stops
1
J,, _ | L J,,, | _J,,,J,L |
3.Not enough spray force
, ,,,_LJ,L
4.Chemical/deter-
gent doesn't combine with water pressure
inside of power washer
Water and/or air pressure too low
=Water and air control knobs not fully open
*Surface heavily soiled
,,1, | ,, i | J, |
•Power Washer is not designed to do this
*Use Maximum water and air pres- sure available (not to exceed 175 psig)
. Open both knobs fully
•Scrub surface with rag or sponge to loosen dirt then rinse with air and water control knobs "ON"
•To Wash or spray chemically usa chemical and air control knobs ON only. To Rfnse, use water and air control knobs ON only.
10