WASHING WiTH THE POWER WASHER
The Power Washer works best usingSears spe0ially formulated concentrateddetergent,
Most common householddetergents are not formulated and concentrated for use in your Power Washer. They are too heavy or thick to pass through your Power Washer and ifthey are dilutedwith water, they lose their cleaning efficiency,
NOTE: If you do not use Sears detergent,
1.Prepare a mixture of detergent in a
2.Attach the garden hose (cold or warm water), air hose, and chemical draw hose to the power washer, Place the free end of the chemical draw hose into
the detergent/water mixture.
. For best performance, set your compressor to the maximum pressure available from your air compres= sor not to exceed 175 psig, Be sure the air and water controls on the power washer are in the "Off" position,
4, Turn the water source fully on and turn on your air
compressor,
5, Begin the washing procedure by adjusting the air control knob and the soap/chemical control knob until they begin spraying the solution onto the sur- face to be washed, The water knob should be OFF. Continue spraying until the surface is completely covered with the solution.
To stop spraying, turn the soap/chemical control knob and the air control knob to the "Off" position,
7.Let the soap remain on the surface for about 30 seconds, A certain amount of wipingwill be required for most types of foreign matter,
,Fully open both the air and water ¢ontrot knobs,
9.Rinse the soap and dirt from the surface you are washing.
SPRAYING FOLIAGE WITH THE POWER WASHER
MANY | CHEMICALS | ARE | TOXIC | OR IRRITATING. | READ THE SAFETY LABEL | ||||||
OR | INSTRUCTIONS | FOR | EVERY CHEMICAL YOU SPRAY. CAREFULLY FOLLOW | ||||||||
ALL |
| INSTRUCTIONS | REGARDING | SKIN, | EYE | AND | RESPIRATORY | PROTECTION. | |||
!. Prepare | a mixture | of chemical | and water | in a | 4. | Foroptimum performance set your air compressor | |||||
bucket or | suitable | container. Carefully |
| pressure between 75 and 125 psig. Be sure the air | |||||||
follow the directions on the chemical container for |
| control | knob is in the | "Off" position. | |||||||
the proper | waterlchemioal ratio. |
|
| 5. | Extend the Foliage Nozzle out as far as it will go. | ||||||
NOTE: Thick or heavy chemicals must be mixed with | 6. Turn on the air compressor. | ||||||||||
7. Begin the spraying procedure by adjusting the air | |||||||||||
water to reduce their thickness, Heavy materials will | |||||||||||
| control knob and the | soap/chemical control knob | |||||||||
not pass through the Power Washer. |
|
|
| ||||||||
2. Attach the chemical draw hose and the air hose to |
| until you are spraying a mist. You may vary the mist | |||||||||
| pattern by pulling the foliage nozzl_ in slightly. | ||||||||||
the Power Washer. Place the free end of the chem- |
| ||||||||||
8. To stop spraying, turn the air control knob and | |||||||||||
|
|
|
|
|
|
|
ical draw hose into the chemica!/water mixture, | the soap/chemical control Knob to the "Off" | |
3. DO NOT attach a hose to the garden hose con- | ||
position. | ||
nector for foliage spraying, Be sure the water | ||
| ||
control knob is in the "Off" position, |
|