Sears 919, 150, 329 owner manual Connecting Electrical Loads

Models: 329 150 919

1 32
Download 32 pages 6.99 Kb
Page 15
Image 15
CONNECTING ELECTRICAL LOADS

NOTE: No choke is required on wa_n ehginex. Mike sure choke is in the "NO CHOKE" posRIon on warm engine atal_,

[ I_KM,_UlIII[II¢I ¢ou Mus'r unplug any load

I lmll_lll:lfrom the g eosr_or before tarring to prevent pern-4nent damage Io any

I applisn©es.

For electric start:

Plaoe OFFIRUN/START sw)tsh in the START position.

NOTE: When the engine starl_ the switch will remain in the RUN position.

F_ rm=_ sta_'.

Place OFFIRUN/STARI" switch in the RUN posi- tion.

STOPPING ENGINE

Dlscoonect all elecffical loads.

*"nJrrlOFF/RUN/START switoh to 'oFF" position.

Cle=mfuel shut-off valve.

indoors, or in enclosed, poorly ventilated orees or I where fuel fum_ may reach an open {lame.

CONNECTING ELECTRICAL LOADS

 

 

 

• Lat onglne mn and warm up for five minutes after

 

 

 

aterdng with no electrical lead.

 

 

 

COnnect loads in the following manner to prevent

Grasp handle on rope starter lind

pull slowly until

 

damage to equipment:

roslatance is felt. Let the rope rewind slowly. Pull

 

Connect inductive IoQdequipment first, inductive

rope with a rapid full arm stroke.

Let rope rewind

 

loads oon_;at of refrigerators, freezers, water

slowly. Repeat if necessa W,

 

 

 

 

pumps, air conditionem, or small hand toots.

NOTE: IF ENGINE OIL LEVEL IS TOO LOW, EN-

 

Connect the items that require the most wattage

GINE WILL NOT START. CHECK OIL LEVEL AND

 

first.

ADD IF NECESSARY,

 

 

Connect the lights next.

 

 

 

When engine warms up, gradually push choke

 

Voltage sensitive equipment should be the last

control In to the N° CHOKE posit!on.

I

equipment oonnectad to the generator. Plug

IMPORTANT: Allow generator to run at no load

voltage sensitive appliances such at TV's,VCR's.

for 5 minutes upon eilch Initial start-up to allow

mi_rowavos, over.s, oomputem, and cordless

engine end generator to stabilize,

 

telephones into a UL listed voltage surge protec-

 

 

tor, then oonne_t the UL Ilstad voltage surge

protector to the genmtor.

IMPORTANT: You should always add up the rated watts of all lights, tools and appllan_s you are powedng at one tim, This total should not exceed the rated oapacPff of you generator or olmuit breaker rating of the receptaole supplying power.

15 --L:NG

O_4Nq,_oul_

Page 15
Image 15
Sears 919, 150, 329 owner manual Connecting Electrical Loads