NOTE: Make aura red batteey boots cover
positive battery oable ton'ninals at battery mid emkmoid
Attimh one end of the negatNe (black) cable te the negative
Attach the other end of the negative (blaok)cable to the tYanteas shown. Install the star washer between the cable and the frame,
IMPORTAN'r: See Caution on page 10 before assembling batter/.
GROUNDING THE GENERATOR
A grounding lug Is suppNed with the generator for use when required by ]oQelelectrical ordinances. Refer to article 250 of the National Ek_ctrlcalCode to clarity any needed grounding information. Your Ioeel electric oompany or s certified electflclan should be able to help you with this informetlon.
anether potash. _t the generat_ and rset the
rm_l abl_er en the wood. _ | This will support |
the gaecane engine dudnO n_mrnbly and meke | |
assembly easier. |
|
• Plaoe a handle cap (7) onto _ | end of handle |
prior to Inatalletfon, |
|
•The handle should be installed on the eleetdcal outlet end of the generator.. Place one washer (12) on long cap screws (1t). Align the handle brack- ets with the upper holes
for frame. Place mentioned screws through frame
and handle brackets. | Secure with lock nuts |
(8) and tighten.
•Locate the engine support. Place one wheel
_'ackst (4) 0_1top of support as shown in Ilisetra- tion. Align with the pre,.drilled holes in support. Piece 2 cap screws (9) through holes in bracket and support. Secure with 2 lock nuts (8) end tighten.
•Insert nee shoulder bolt (2) into Wheel (1). Insert
threaded end of her through wheel bracket, secure with look nut (3) and tighten. NOTE: The wheel wHI not rub frame If instannod properly,
•Repeat the above steps for the opposite side.
•insert the threaded stud of rubber foot (10) through the middle hole of the foot bracket (5),
Secure with lock nut (8) and t_ghten.
•Lecete the support under the elestrioal outlet end of the generator. Position foot bracket (5), with rubber foot instead, under the support and al)gn the holes In the foot bracket (5) with the slots in
the support. Place one sap screw (9) through each slot in the support end the holes in the foot
bracket. Secure with the lock nuts (8) and tighten.
•Once completed, the wheel Mt is ready for use,
NOTE: Yourengineis already g_unded tOthe frame by a groundingstrap.
INSTALLING WHEEL KIT
The Craftsman Wheel Kit was dsegned to gmmly improve the portabll/ty of your generator.
assembling the portability
kit. Fall |
| |
kit. Failure to die so will cause damxge to the |
| |
JI |
| |
engine. |
| |
NOTE: AJwaysfollow stets regulations for proper ell |
| |
dispcesi. |
| |
Place generator on level ground; d_dn all gas and |
| |
oil from the engine (sea engine manual for ocrmct |
| |
pressure). | 8 | |
• Piaceal'thiokxl"squampleceofwoodonthe | ||
g | ||
ground In front of the engine, With the help of | ||
| 1o |
1
12
11
DtoJlr _o_
