SETUP FOR ADVANCED USERS
Install Print Drivers
Be sure to install the necessary print drivers on each computer that will be accessing the Print Server.
Set Up Print Server
1.Plug your printer (power on) into the Print Server.
2.Power up the Print Server within wireless range of your 802.11g or 802.11b wireless network.
3.Allow approximately one minute for the Print Server to boot.
4.Verify that the Status light is illuminated and that the Error light is not illuminated.
5.Determine the Print Server’s IP address, using one of the following methods:
a)New Print Servers are configured to receive IP addresses dynamically. If your network has a DHCP server, the Print Server will obtain an IP address from your network. If the DHCP server supports a client list, the client list will list the IP address assigned to the Print Server. If a DHCP server is not available, after 1.5 minutes the Print Server will revert to to 192.168.2.253.
b)If the Print Server has been configured previously, then it will have been set to a static IP address that could be different for
every network.
Note: Restoring factory defaults on the Print Server by holding in the reset button for 10 seconds while repowering the Print Server will restore the IP address to dynamic.
c)Run the program “PSF.exe” from the Installation CD. This will find the IP address and link automatically to the
d)Go to the last step of the Print Server Installation Wizard, which has an Advanced button that finds the IP address and links automatically to the
8
