iMPORTANT

Safe Operation Practices for Walk-Behind Snow Throwers

This snow thrower is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury.

&Look for this symbol to point out ira= portant safety precautions. It means CAUTION!!! BECOMEALERT!!! YOUR SAFETY IS INVOLVED.

WARNING: Always disconnect spark

&plug wire and place it where it cannot contact plug in order to prevent acci= dental starting when setting up, trans- porting, adjusting or making repairs.

WARNING: This snow thrower is for

use on sidewalks, driveways and other ground level surfaces. Caution should

be exercised while using on sloping sur= faces. Do not use snow thrower on

surfaces above ground level such as roofs of residences, garages, porches or other such structures or buildings.

&

_

&

WARNING: Snow throwers have ex=

posed rotating parts, which can cause severe injury from contact, or from ma= terial thrown from the discharge chute. Keep the area of operation clear of all persons, small children and pets at all times including startup.

CAUTION:parts becomeMufflerextremelyand otherhot engineduring operation and remain hot after engine

contact,has stoppedstay. Toawayavoidfromseveretheseburnsareason.

WARNING: Engine exhaust, some of its constituents, and certain vehicle

components contain or emit chemi= cals known to the State of California

to cause cancer and birth defects or other reproductive harm.

Training

1.Read, understand and follow all instructions on the machine and in the manual(s) before operating this unit. Be thoroughly familiar with the controls and the proper use of the equipment. Know how to stop the unit and disengage the controls quickly.

2.Never allow children to operate the equipment. Never

allow adults to operate the equipment without proper instruction.

3.Keep the area of operation clear of all persons, par- ticularly small children.

4.Exercise caution to avoid slipping or falling, especially when operating the snow thrower in reverse.

Preparation

1.Thoroughly inspect the area where the equipment is to be used and remove all doormats, sleds, boards, wires, and other foreign objects.

2.Disengage all clutches and shift into neutral before starting the engine (motor).

3.Do not operate the equipment without wearing adequate winter garments. Avoid loose fitting clothing that can get caught in moving parts. Wear footwear that will improve footing on slippery surfaces.

4.Handle fuel with care; it is highly flammable

(a)Use an approved fuel container.

(b)Never add fuel to a running engine or hot en- gine.

(c)Fill fuel tank outdoors with extreme care. Never fill fuel tank indoors.

(d)Never fill containers inside a vehicle or on a truck or trailer bed with a plastic liner. Always place containers on the ground, away from your vehicle, before filling.

(e)When practical, remove gas-powered equipment from the truck or trailer and refuel it on the ground. If this is not possible, then refuel such equipment on a trailer with a portable container, rather than from a gasoline dispenser nozzle.

(f)Keep the nozzle in contact with the rim of the fuel tank or container opening at all times, until refuel-

ing is complete. Do not use a nozzle lock-open device.

(g)Replace gasoline cap securely and wipe up spilled fuel.

(h)If fuel is spilled on clothing, change clothing im- mediately.

5.Use extension cords and receptacles as specified by the manufacturer for all units with electric drive motors

or electric starting motors.

. Adjust the collector housing height to clear gravel or crushed rock surface.

7.Never attempt to make any adjustments while the engine (motor) is running (except when specifically recommended by manufacturer).

. Always wear safety glasses or eye shields during op- eration or while performing an adjustment or repair to

protect eyes from foreign objects that may be thrown from the machine.

Operation

1.Do not put hands or feet near or under rotating parts. Keep clear of the discharge opening at all times.

2.Exercise extreme caution when operating on or cross- ing gravel drives, walks, or roads. Stay alert for hidden hazards or traffic.

3.After striking a foreign object, stop the engine (motor), remove the wire from the spark plug, disconnect the cord on electric motors, thoroughly inspect the snow thrower for any damage, and repair the damage before restarting and operating the snow thrower.

4.If the unit should start to vibrate abnormally, stop the engine (motor) and check immediately for the cause. Vibration is generally a warning of trouble.

5.Stop the engine (motor) whenever you leave the oper-

 

ating position, before

unclogging the collector/impeller

 

housing or discharge chute, and when making any

2

repairs, adjustments

or inspections.

Page 2
Image 2
Sears 944.529571 owner manual Safe Operation Practices for Walk-Behind Snow Throwers