Check TiRE Pressure | Sears 944.529571 specs

ASSE BLY/PRE-OPERATION

iNSTALL CHUTE DEFLECTOR REMOTE CONTROL

(See Figs. 8 and 9)

1.Install remote cable bracket to discharge chute with 5/16-18 carriage bolt and 5/16-18 Iocknut as shown. Tighten securely.

2.Install remote cable eyelet to chute deflector with 1/4-20 shoulder bolt and 1/4-20 Iocknut as shown. Tighten nut securely. Cable eyelet will be loose on shoulder bolt.

3.Install spring hooks between hex nuts on chute rotater head and into hole in chute deflector as shown.

1/4-20	SPRING
	CHUTE
SHOULDER	DEFLECTOR

1/4-20

LOCKNUT f_

5/16-18

CARRIAGE

CABLE

EYELET

REMOTE

/CABLE

/BRACKET

5/16-18

LOCKNUT

FIG. 8

CHECK TiRE PRESSURE

The tires on your snow thrower were overinflated at the fac- tory for shipping purposes. Correct and equal tire pressure is important for best snow throwing performance.

•Reduce tire pressure to 14-17 PSI.

CHUTE DEFLECTOR CONTROLLEVER

FIG, 9

8

Image 8

Sears 944.529571 owner manual Check TiRE Pressure

Contents

OW TH SE IES E E 27 TWO-STAGEPowe -P Elle Safe Operation Practices for Walk-Behind Snow Throwers Contents Page Shearboltsandnuts Parts Packe ELY I CartonOperatio Install Traction Drive Control ROD Asse BLY/PRE-OPERATIONUnfold Upper Handle See Figs Operatic Install Discharge Chute / Chute RotaterASS Check TiRE Pressure Know Your Snow Thrower Or WarningIgnition KEY RUN Pull OUT to Stop Disengaged Meets A.N.SJ. Safety Requirements Operati To unclo the chute and/or au er HOW to USE Your Snow ThrowerTimes including startup Operation To Throw Snow See Fig Before Starting the Engine To Start Engine Before Stopping General Recommendations Before Each USESnow Thrower Fill in Dates Cleaning Engine Equipment shear bolts as supplied with your snow thrower To Adjust Snow Thrower HeightSeadj Ents Seadj Carburetor Engine Speed Storage OtherFuel System Engine OIL Problem OTI \17 DESCRiPTiON KEY Part Description Description Description Skid Plate LH Skid Plate RH Description Auger Bearing Bearing Plug Control Panel / Discharge Chute Part Description Handles Interlock Repair Partssnow Thrower - Model Number 944,529571 Spacer Impeller ROD Assembly Traction ROD AssemblyShifter ROD TOP Shifter ROD Bottom Wire Harness Lower TubePivot Support Panel Console Repair Parts Snow Thrower - Model Number 944,529571 Drive Rubber Ring Assembly Drive Plate AssemblySpeed Selector Wheel HUB Axle Assembly Axle ShaftSprocket TH Rust Wash ER Chassis / Pulleys KEY Part DescriptionEngine Mount Plate Engine Model Cover Assembly Impeller Idler PulleyENG Impeller Idler ARM Steering Bracket Pivot BracketWheel Driver Bellcrank Cable Bracket Wheel AssemblyPart Description Safety Ignition KEY BAG of PartsKEY Part NO. no Locknut 3/8-16 Washer 3/8 Decals KEY Part Briggs & Stratton 4-CYCLE Engine 161 Model Number 20M314-1370-E2 528j!i Briggs & Stratton Cycle Engine Engine Power Rating information Service Notes 800-.4-.MY-.HOME