Sears BFPR100 - page 10

STEP

Be careful to assemble all components

in the sequence they are presented.

NOTE:

Finger tighten all hardware in this step. DO NOT wrench tighten until the last step.

Some components may be pre-assembled. Nylon lock nuts will not fully screw onto

bolts, they must be wrench tighten to fully go on.

1A. Install four Foot Caps (#5) in Frame A (A) and Frame B (B).

1B. Install two Clip-On Spacers (#6) on Frame A (A) and Frame B (B).

1C. Attach Frame A (A) and Frame B (B) to Frame C (C) using:

4 - (#1) M10X70mm Hex Head Bolt

8 - (#3) ø11Xø30X2.5mm Flat Washer

4 - (#4) M10 Nylon Lock Nut

Contents

Main WARNING, SAFETY, & MAINTENANCE DO NOT REMOVE WARNING LABELS FROM MANUAL OR MACHINE WARNING! TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS Page PFPR100 - HARDWARE LIST HARDWARE ILLUSTRATION PART LIST/ILLUSTRATION Page Page Page 12 Be careful to assemble all components in the sequence they are presented. Page 14 Be careful to assemble all components in the sequence they are presented.