S T E P

3

Be careful to assemble all components

in the sequence they are presented.

NOTE:

Finger tighten all hardware first in this step. Wrench tighten ALL hardware at the end of STEP 3C. Some components may be pre-assembled. Nylon lock nuts will not fully screw onto bolts, they must be wrench tighten to fully go on.

3A. Install four End Caps (#7) in two Frame E (E).

3B. Attach one ends of two Frame E (E) and Frame C (C) to Frame D (D) using:

4 - (#2) M10X75mm Hex Head Bolt

8 - (#3) ø11Xø30X2.5mm Flat Washer

4 - (#4) M10 Nylon Lock Nut

3C. Attach another ends of Frame E (E) and Chin Up Bar (F) to Frame D (D) using:

4 - (#2) M10X75mm Hex Head Bolt

8 - (#3) ø11Xø30X2.5mm Flat Washer

4 - (#4) M10 Nylon Lock Nut

14

Page 14
Image 14
Sears BFPR100 owner manual E P