Sears RFG297AA setting uP tHe ReFRigeRAtoR, Removing the refrigerator doors, Tools you will need

setting uP tHe ReFRigeRAtoR

Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.

1.Place the Refrigerator in an appropriate location with reasonable clearance between the wall and the Refrigerator. Refer to installation instructions in this manual.

2.Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.

3.Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly chilled and the motor will run smoothly.

4.After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can store food and drinks in the Refrigerator after the temperature is sufficiently cool.

Check the accessory list below.

PU G ESTTIN 01

Water filter	Hex wrench	Fastener	Compression fitting	Compression nut
(DA29-00003B)	(DA80-00002C)	(DA60-00143B)	(DA62-00305A)	(DA74-00070B)

Removing the refrigerator doors

If the Refrigerator is too large to pass through your doorway easily, you can remove the refrigerator doors.

Tools you will need

Philips screwdriver Flat-blade screwdriver Wrench Pliers Allen wrench(3/16”)

Disassemble the Refrigerator doors

1.With the door opened, remove the Top Table cap ( 1 )with a Flat head screwdriver, and close the door.

Remove the 3 screws holding down the Top Table and remove the Top Table( 2 ).

2

1

2. Disconnect the electrical connector ( 3 ) above	4
the upper right door hinge and the 3 electrical
connectors ( 4 ) above the upper left door hinge.
Disconnect the water tube ( 5 ) by pulling the tube
fitting ( 6 ) apart as shown in the picture.
5

3

6

Setting Up _9