SECO-LARM USA EV-1826-PKGQ, EV-1826-NKGQ manual Dimensions, Overview, Before Starting, Installation

ENFORCER 84-IR LED Bullet Cameras

Dimensions:

45/16”

(109mm)

101/4” (260mm)

1013/16” (275mm)

45/8” (116mm)

45/8”

(118mm)

Overview:		Sunshield		Mounting base
	Sunshield
	screw	Mounting arm		Surface mount	Female BNC connector
				knock-out
		adjustment screw
				Remove with a pair of
				pliers	DC Plug with
					terminal block
		Camera angle	Mounting	Adjustment	DC jack
		adjustment screw	arm	screw
Zoom	Focus		Adjustment nut

Before Starting:

1.Please read this manual carefully and keep it for future reference.

2.Use the camera within given temperature and electrical limits.

3.Do not aim the LED light directly at the eyes when the LEDs are on.

4.Do not point the camera at the sun. Heat could damage the camera, even when not in use.

5.Do not mount the camera in areas exposed to radiation, strong magnetic fields, or strong electrical signals.

6.Do not open or disassemble the camera. There are no field serviceable parts inside.

7.Do not drop the camera or subject it to strong vibrations.

Installation:

1.Run a 12VDC power supply wire and a video cable with a male BNC connector through the wall to where the camera is to be mounted.

2.Temporarily connect the camera to the 12VDC power supply. Do not cut the DC jack or female BNC plug as warranty will be voided. If needed, use the included SECO-LARM DC plug with

terminal block.

3.Temporarily connect the camera’s female BNC jack to the video cable’s male BNC plug. While watching the monitor, hold the camera bracket by hand against the wall where it is to be mounted, then twist the camera until it is certain that this mounting location is correct. Use a pencil to mark the location of the four screw holes in the bracket.

4.Disconnect the 12VDC power supply and video cable.

5.Mount the bracket to the wall using the four included mounting screws.

6.If mounting to the EV-11LR or EV-11LS, see instructions on page 2.

7.Reconnect the 12VDC power supply and video cable. Turn the monitor on and make sure the camera is sending the proper video signal.

8.To adjust the camera angle, loosen and tighten the adjustment nut, or loosen and tighten either of the two screws on the mounting arm. Adjust until the desired scene is displayed.

9.Adjust the zoom and focus using the included hex wrench.

10.Do a final test of the video camera and monitor.

SECO-LARM U.S.A., Inc. 3