ENFORCER Vandal
Overview:
Case | Camera ball | Screws | Base | ||
(Only 2 shown. Use all 4 when installing.) | |||||
|
|
|
|
|
|
Female BNC connector
DC Plug with terminal block
DC Jack | OSD Controller | |
(3X Models only) | ||
|
Before Starting:
1.Please read this manual carefully and keep it for future reference.
2.Use the camera within the given temperature and electricity limits.
3.Do not point the camera at the sun. Heat could damage the camera, even when not in use.
4.Do not drop the camera or subject it to strong vibrations.
5.Do not mount the camera in areas exposed to radiation, strong magnetic fields, or strong electrical signals.
Installation:
1.Run a 12VDC power supply wire and a video cable with a male BNC connector through the wall to where the camera is to be mounted.
2.Loosen the set screws with the included hex wrench and remove the case from the base.
NOTE: The camera ball is NOT attached to the case or the base. It sits loose inside the case. Therefore, be very careful when removing the case from the base. Do not drop the camera ball.
3.Mount the base to the wall using the four included mounting screws. If the wall is made of dry wall, brick, or similar material, it may be necessary to use the included plastic screw anchors.
4.Run the camera’s BNC and power connectors through the camera base, and connect to the video and power wires that were run through the wall.
5.Put the case over the cameral ball onto the base. Be careful to not drop the camera ball.
6.Holding the case loosely on the base, turn the camera ball to the desired direction.
NOTE: Before securing installation, make sure to check both the day and night images. Adjust the camera ball in a way so that there are no objects blocking or obscuring the camera’s view.
7.3X Models Only: Use the OSD controller joystick to adjust camera settings (see the separate OSD manual).
8.Once the ball is pointing in the desired direction, tighten the outer case ring to secure the camera in
its position.
9. Do a final test of the video camera and monitor.
3 |
