ENFORCER Outdoor
Programming Tips
Program new Master Code immediately.
Program the Output #1 access mode immediately, or the keypad will only accept user cards.
Take note of the keypad status LEDs— o Right LED Green: Standby
o Left LED Solid Red/Right LED Solid Orange: Programming Mode
o Right LED Flashing Orange: Awaiting code/card entry
If unsure of which mode the keypad is in, press 
until the right LED is green. The keypad is now in the standby mode. Enter the master code twice to return to Programming Mode.
For complete programming instructions, see page 10 of the User Manual.
Programming the Master Code
1.Enter Programming Mode by entering the Master Code twice. (Default Master Code is 12345)
2. Enter 
3
.
3. Enter the new
Example: If the desired new Master Code is 54321, enter:
5 
4 
3 
2 
1 
5 
4 
3 
2 
1
4. Exit Programming Mode by pressing 
.
Setting the Output #1 Access Mode*
DEFAULT: User card only. To use codes, you MUST set mode to
1. | Enter Programming Mode by entering the Master Code twice. | ||
2. | Enter | 0 . | |
3. Enter one of the following: | |||
| 0 | 0 | User card ONLY (DEFAULT) |
| 0 | 1 | Either user card OR user code |
| 0 | 2 | User card AND user code |
0 
1
or
0 
2
.
Note: The Output #1 Access Mode must be programmed in order for the
4. Exit Programming Mode by pressing 
.
2 |
