ENFORCER Outdoor
Programming Output #2
Each Output #2 user may only have a user code OR a user card programmed.
2.1Programming an Output #2 User Code
1.Enter Programming Mode by entering the Master Code twice.
2.Enter 4 .
3. Enter a user ID number. ( 0 0 to 0 9 )
4.If the left LED is red, previous user data exists. Clear it by entering . The keypad will beep in confirmation and the left LED will turn green.
5.Enter a new
6.To program the next user, repeat from step 3 in section 2.1 or 2.2.
7.Return to Programming Mode by pressing .
8.Exit Programming Mode by pressing again .
2.2Programming an Output #2 User Card*
1.Enter Programming Mode by entering the Master Code twice.
2.Enter 4 .
3. Enter a user ID number. ( 0 0 to 0 9 )
4.If the left LED is red, previous user data exists. Clear it by entering . The keypad will beep in confirmation and the left LED will turn green.
5.Swipe a new user card.
6.To program the next user, repeat from step 3 in section 2.1 or 2.2.
7.Return to Programming Mode by pressing .
8.Exit Programming Mode by pressing again.
NOTICE: The information and specifications printed in this manual are current at the time of publication. However, the
Copyright © 2010
16842 Millikan Avenue, Irvine, CA 92606 | Website: |
Tel: |
PICCN2
4 |