SECO-LARM USA SK-910R3Q Overview, Transmitter Programming Button Operation One per Channel

ENFORCER Three- and Four-Channel RF Receiver

Overview:

CH 3 Mode switch

CH 2 Mode switch

CH 1 Mode switch

	Sec.	SW1	SW2	SW3
CH 4 Mode switch (4-Channel models only)	1	On	Off	Off
Programming mode switch	2	Off	On	Off
Time programming DIP switch	3	Off	Off	On
	4	On	Off	On
	5	Off	On	On
	10	On	On	Off
	30	Off	Off	Off
	60	On	On	On

Power Input	Status LED
11~24 VAC/VDC
Channel 1	Channel 4 (4-Channel models only)
Channel 2	Channel 3

If an optional antenna is used, LP3 must be cut and the antenna slot on the receiver case must be chipped off to accommodate the extended range antenna wire.

(PC Board shown. Remove the front cover of the receiver to access the mode buttons and terminal block.)

Transmitter Programming Button Operation (One per Channel):

Learn mode	Press and hold the transmitter programming button for three seconds or more.
Clear memory	Press and hold the transmitter programming button for three seconds or more, then when the
	LED starts flashing, press again for three seconds to delete all previously learned codes.
Reset latched output	If this channel was programmed for latch output, once the relay is turned ON with a transmitter
	button, press the transmitter programming button of that channel once to turn the relay OFF.
Memory display	Press and release the transmitter programming button to show the number of codes stored. The
	LED will flash a number of times corresponding to the number of codes stored.

LED Indication (One per Channel):

Steady ON	Senses signal from a transmitter button in normal operation, or indicates a transmitter button’s
	code already exists in the receiver’s memory during code learning.
Fast flash	In the code-learning mode or channel memory display mode, or during the programming channel
	output mode.
One flash	A transmitter button code was learned, or the relay is in timed output mode.
Two flashes	All previously learned transmitter buttons were deleted, or the relay is in toggle
	output mode.
Three flashes	Latch output.
Four flashes	Validity output.
0~15 flashes	In the normal operation mode, pressing the channel mode button once will display the number of
	codes learned.

Extended Range Antenna (Optional):

Extends RF receiver range up to 1,000ft (304m) (open air) with	SK-91ERSD
existing remotes.
Comes with a 9ft cable that easily plugs into the 3-pin antenna port
located on the RF receiver.
NOTE:

∙If an extended range antenna is used, the “LP3” on the receiver PC board must be cut.

∙Actual antenna range will vary greatly depending on the operating environment.

SECO-LARM U.S.A., Inc. 3