Important! Saving new settings in a memory area automatically replaces any settings previously stored in that memory area.
1.Use the Preset button on the control panel to choose the memory area where you want to store your projector settings. The status light indicates the currently selected memory area (1, 2, or 3). Pressing the Preset button changes the selected memory area (or turns off the projector setup feature) in this sequence:
2.While the status light for the memory area you want is lit, check the projected image and make your projector settings. You can adjust the following settings:
•Sync, tracking, brightness, contrast, and vertical and horizontal position for a computer image
•Brightness, contrast, color, and tint (NTSC only) for a video image.
See “Using the control panel” on page 26 in Chapter 2 and “Using the Main Menus” on page 30 for instructions on changing projector settings.
3.After you select your projector settings, hold down the Preset button for about three seconds, until the memory area status light starts flashing. Then release the Preset button; the status light stops flashing and stays on, and the projector setup is stored in the selected memory area.
| Using Projector Setups | 39 |