Senco PC2053-1 owner manual Specifications, Glossary, Duty Cycle, Storage

SPECIFICATIONS

Model No.

Horsepower SCFM @ 40 psig SCFM @ 90 psig Cut-In Cut-Out Voltage-Single Phase

Minimum Branch Circuit Requirement *Fuse Type

Amperage at Max. Pressure

PC2053-1

2

3.6

2.5

100PSI

125 PSI 120/60/1 15 AMPS

Time Delay 10 AMPS

GLOSSARY

SCFM or CFM: Standard Cubic Feet per Minute; a unit of measurement of air delivery.

PSIG or PSI: Pounds per square inch gauge.

CUT-IN PRESSURE: While the motor is off, air tank pressure drops as you continue to use your accessory. When the tank pressure drops to approximately 100 PSI the motor will restart automatically. The low pressure at

which the motor automatically re-starts is called "cut-in pressure."

CUT-OUT PRESSURE: When you turn on your air com- pressor and it begins to run, air pressure in the air tank begins to build. It builds to to approximately 125 PSI before the motor automatically shuts off .The high pressure at which the motor shuts off is called "cut-out pressure."

DUTY CYCLE

This air compressor's optimum life may be achieved by operating the unit at a 50 % duty cycle, or less.

A 50% duty cycle is considered to be 30 minutes of 'run time' in any 1 hour time period.

Should the unit operate at a greater than a 50% duty cycle, then the compressor may be undersized for the required job demand and continued operation above a 50% duty cycle may constitute misuse of the product.

This air compressor is specifically designed for use in lighter duty contractor finishing applications. Use in any other application requiring higher performance or longer duty cycle operation may cause premature failure.

STORAGE

When you have finished using the air compressor:

1.Set the "ON/OFF" switch to "OFF" and unplug the cord.

2.Relieve all pressure from the air compressor head and air hose by opening the regulator.

3.Protect the electrical cord and air hose from damage by winding them loosely around the air compressor.

4.Store the air compressor in a clean and dry location.

D23708 6-ENG