Configuring the receiver

￿

B

A

To copy the settings:

￿Place the receiver (A) above the infra-red interfaces B of the other receivers (B), one after the other. The distance between the infra-red interfaces must not exceed 10 cm.

The settings are copied and “Copy” briefly appears on the display panels of the receivers (B). If data transfer was successful, the receiver (B) switches off automatically.

Strong extraneous light may interfere with the data transfer via the infra-red interface. Therefore, position the receivers so that any possible interference caused by extraneous light is avoided. The blue line between the infra-red interfaces B in the diagram on the left indicates the direction from which the IR radiation must impinge upon the receiver.

max. 10 cm

If you are using receivers from different frequency ranges and if you have set a frequency that is not available in the frequency range of the receiver (B), “Incompatible Frequency” appears on the display panel.

￿Use receivers from the same frequency range or set a frequency that is available in both frequency ranges.

The “Channels” menu

Calling up the “Setup Ch 1” ... “Setup Ch 32” menu

Setup

 

 

 

 

 

Channels

 

 

Setup Ch 2

 

 

 

 

 

 

 

 

Channels

 

 

 

 

Setup Ch

2

 

 

 

 

Name

 

 

 

 

 

 

 

 

 

 

 

Call up

 

 

 

Select and call up

 

“Setup Ch 1” ...

“Channels”

 

 

 

channel “1“ ... “32“

 

“Setup Ch 32” menu

 

 

 

 

 

 

 

 

 

 

 

 

is reached

Via the “Channels” menu, you can call up the “Setup Ch 1” ... “Setup Ch 32” submenu.

The “Setup Ch 1” ... “Setup Ch 32” menu

Entering a name – “Name”

Setup Ch 2

 

 

 

 

 

Name

 

 

 

Name

 

 

 

 

 

 

 

 

 

Name

 

 

 

 

 

W

nglish

 

 

 

E

n

glish

 

 

 

 

 

 

 

 

 

 

Wnglish

 

 

 

 

 

 

 

 

 

 

 

 

 

Call up “Name”

 

 

 

Enter a character

 

 

Enter a character;

 

 

 

 

 

 

and confirm

 

 

store the setting

“Stored”

Via the “Name” menu, you can enter a freely selectable name for the receiving channel (e.g. the language of the guided tour). The name is displayed on the standard display and can consist of up to 8 characters such as:

•letters (without pronounciation marks),

•numbers from 0 to 9,

•special characters and spaces.

To enter a name, proceed as follows:

 

￿

Press the rocker button to select a character.

SET

￿ Press the SET button to change to the next segment/character or to

 

 

store the complete entry.

Tourguide 1039 19