18
Putting the products into operation
12 rack mount “ears”
21 blanking plate
31 jointing plate
42 R-SMA extension cables
5Screw-in R-SMA sockets
6R-SMA connectors with washers and nuts
72 blanking plugs for closing off the antenna holes in the blanking plate
82 recessed head screws
96 recessed head screws
Mounting a single receiver into a rack
왘Unscrew and remove the four screws located on the sides of the receiver
housing.
왘Secure the rack mount “ears” 1 to the sides of the receiver using the pre-
viously removed recessed head screws (see right-hand diagram).
Make sure that the angled ends of the rack mount “ears” point forward.
왘Secure the blanking plate 2 to one of the rack mount “ears” 1 using the
two recessed head screws 8.
Make sure to use the correct side (the one with the round holes) of the
blanking plate 2 to secure it to the rack mount “ear”.
If you want to mount the supplied rod antennas to the front of the rack:
왘Read the next section.
If you do not want to mount the supplied rod antennas to the front of the rack:
왘Insert the two blanking plugs 7 into the unused antenna holes.
왘Slide the receiver into the 19" rack.
왘Secure the rack mount “ears” 1 and the blanking plate 2 to the rack.
2
1
7