Synchronizing a transmitter with the receiver
Synchronizing a transmitter with the receiver
When synchronizing a transmitter with a diversity receiver, please observe the following:
Only use a transmitter and a diversity receiver from the same frequency range (see the type plates on the transmitter and the diversity receiver).
Make sure that the desired frequencies are listed in the enclosed frequency information sheet.
You can also contact your Sennheiser partner who will be pleased to calculate
Make sure that the desired frequencies are approved and legal in your country and, if necessary, apply for an operating license.
Upon delivery, transmitter and diversity receiver are synchronized with each other. If, however, you cannot establish a transmission link between transmitter and diversity receiver, you have to synchronize the channels of the devices:
Deactivate the RF signal on all transmitters (see the instruction manual of the transmitter).
This prevents that, during the frequency scan, the channels used by
With a diversity receiver, perform a frequency preset scan to scan the frequency banks for unused channels (“Scan New List”, see page 23).
Select a frequency bank and a channel on this diversity receiver (“Current List”, see page 22).
If you want to set up a
Via the “Sync Settings” submenu, you can set additional transmitter parameters directly on the diversity receiver and activate or deactivate the transfer of these parameters to the transmitter (see page 28).
Synchronize a transmitter with the diversity receiver (see page 19). The receiver’s frequency, name, pilot tone setting and, where applies, additional parameters activated via the “Sync Settings” submenu are transferred to the transmitter.
30