|
| Accessories | |
|
|
| |
Problem | Possible cause | Possible solution |
|
Audio signal is | Transmitter sensitivity | Adjust the transmitter |
|
distorted | is adjusted too high | sensitivity correctly |
|
|
| (see the instruction manual |
|
|
| of the transmitter). |
|
| Receiver’s audio output | Reduce the audio output level |
|
| level is adjusted too | (“AF Out”, see page 24). |
|
| high |
|
|
No access | During scanning, | Set the transmitter operating |
|
to a certain | an RF signal has been | on this channel to a different |
|
channel | detected on this | channel and redo the |
|
| channel and the | frequency preset scan |
|
| channel has been locked | (see page 22). |
|
| During scanning, a | Switch the transmitter off and |
|
| transmitter of your | redo the frequency preset scan |
|
| system operating on | (see page 22). |
|
| this channel has not |
|
|
| been switched off |
|
|
|
|
|
|
If a problem occurs that is not listed in the above table or if the problem cannot be solved with the proposed solutions, please contact your local Sennheiser partner for assistance.
To find a Sennheiser partner in your country, search at
www.sennheiser.com under “Service & Support”.
Accessories
The following EK 2000 accessories are available from your specialist dealer:
009950 BA 2015 accupack
009828 L 2015 charger
009827 DC 2 power adapter for external DC powering (12 V)
009986 CA 2 camera adapter
005022 CL 1 line cable (jack to jack, balanced)
087047 CL 500 line cable
35