Synchronizing a transmitter with the receiver

OR:

￿Manually set the transmitter to the same frequency bank and channel that you set on the receiver.

￿Activate the RF signal on this transmitter. The transmission link is established.

If you want to set up a multi-channel system:

￿Repeat the following 4 steps for each additional transmission link:

Perform a frequency preset scan with the next diversity receiver.

Select a channel from the same frequency bank as with the first diversity receiver.

Synchronize a transmitter with the diversity receiver.

Activate the RF signal on the transmitter.

Using freely selectable receiving frequencies

You can also freely select the receiving frequencies and store these frequencies in the frequency banks “U1” to “U6”.

It might be that the freely selected frequencies are not intermodulation -free

If you are using frequencies from the frequency banks “U1” to “U6”, it might be that the receiving frequencies are not intermodulation -free.

￿Contact your Sennheiser partner who will be pleased to calculate intermodulation-free frequencies for you (see www.sennheiser.com).

￿Set each diversity receiver to the same frequency bank (“U1” to “U6”).

￿On one of the receivers, select a channel within this frequency bank and assign this channel a receiving frequency (see page 25).

￿Synchronize a transmitter with this receiver (see the instruction manual of the transmitter).

OR:

￿Manually set the transmitter to the same frequency bank and channel that you set on the receiver.

￿Repeat for the remaining transmitters and receivers as described above.

31