Using the receiver

**2000**

200MHz

SKM2000

TE

Using the receiver

To establish a transmission link, proceed as follows:

1.Switch the receiver on (see next section).

2.Switch the transmitter on (see the instruction manual of the transmitter).

The transmission link is established and the display backlighting of the receiver changes from red to orange.

It is vital to observe the notes on frequency selection on page 31.

If you cannot establish a transmission link between transmitter and receiver, read the chapter “Synchronizing transmitters with receivers” on page 31.

Switching the receiver on/off

￿To switch the receiver on:

￿Briefly press the STANDBY button ￿.

The receiver switches on and the “Receiver Parameters” standard display

appears.

To switch the receiver to standby mode:

￿Keep the STANDBY button ￿ pressed until “OFF” appears on the display panel. The receiver switches to standby mode. The integrated antenna splitter and the booster supply voltage remain active so that the antenna signals are still looped through to daisy-chained receivers.

When in the operating menu, pressing the STANDBY button ￿ will cancel your entry (ESC function) and return you to the current standard display.

The STANDBY button ￿ is backlit in red both during operation and in standby mode.

To completely switch the receiver off:

￿If necessary, deactivate the lock mode (see page 15).

￿Disconnect the receiver from the mains by unplugging the mains cable plug from the wall socket.

The backlighting of the STANDBY button ￿ goes off.

 

 

 

 

Monitoring the audio signal via headphones

CAUTION!

 

 

 

Danger of hearing damage!

 

 

 

 

Listening at high volume levels for long periods can lead to permanent hearing defects.

 

 

 

 

￿ Set the headphone volume control ￿ to the minimum position before putting the head-

 

 

 

 

phones on.

 

 

PEAK0

B.Ch:

￿ Set the headphone volume control ￿ to the minimum position.

True Diversity Receiver EM 2000

40

￿ Connect headphones with a ¼” (6.3 mm) stereo jack plug to the headphone output ￿.

 

30

-10

 

 

20

-20

EQ:

 

-30

 

10

-40

￿ Gradually increase the volume and monitor the audio signal with the lowest possible

 

RF

AF

P + 1

volume.

￿ ￿

14