Synchronizing transmitters with receivers

Synchronizing transmitters with receivers

When synchronizing a transmitter with a receiver, please observe the following:

￿Only use a transmitter and a receiver from the same frequency range (see the type plates on the transmitter and the receiver).

￿Make sure that the desired frequencies are listed in the enclosed frequency infor- mation sheet.

￿Make sure that the desired frequencies are approved and legal in your country and, if necessary, apply for an operating license.

Synchronizing a transmitter with the receiver – individual operation

Upon delivery, transmitter and receiver are synchronized with each other. If, however, you cannot establish a transmission link between transmitter and receiver, you have to synchronize the channels of the devices:

￿With the receiver, perform a frequency preset scan to scan the frequency banks for unused channels (“Scan New List”, see page 23).

Then “Sync” appears on the display panel of the receiver.

 

 

 

PEAK

 

Easy Setup

 

 

 

 

40

0

 

 

 

 

 

30

 

-10

 

 

 

ew300 G3

 

 

 

-20

 

 

 

 

20

 

-30

 

B.Ch: 20.

24

 

 

 

 

 

 

 

10

 

-40

 

Sync 531.375 MHz

 

 

 

 

RF

 

AF

 

￿Synchronize a transmitter with the receiver via the infra-red interface (see page 15). This establishes a transmission link between the transmitter and the receiver.

Alternatively, you can set the channel on the transmitter manually:

￿Make sure that you set the transmitter to the same frequency bank and the same channel as the receiver.

Network operation

WSM

Synchronizing transmitters with receivers – multi-channel operation

In order to ensure an intermodulation-free transmission, use the same frequency bank for all transmission links.

Combined with 2000 series transmitters, 2000 series receivers can form transmission links that can be used in multi-channel systems. In multi-channel operation, the receivers are remote controlled via a PC running the “Wireless Systems Manager” (WSM) software. For further information on downloading the software, visit the ew G3 product page on our website at www.sennheiser.com.

Advantages of controlling the receivers via the “Wireless Systems Manager” (WSM) software:

•Detailed overview of all receiving channels

•Remote control of all receivers in the network

•Combination of receivers of different frequency ranges (see page 4).

￿Connect the receivers in a network (see page 12).

31