￿ ￿

￿￿

Using the receiver

Synchronizing a transmitter with the receiver

You can synchronize a suitable transmitter of the 2000 series with the receiver. By default, the following parameters are transferred to the transmitter during synchronization:

Setting

Transferred parameter

“Frequency Preset” Currently set frequency

“Name”

Freely selectable name currently set on the receiver

“Pilot Tone”

Current pilot tone setting of the receiver (“Inactive”/“Active”)

 

 

Via the “Sync Settings” submenu, you can adjust additional parameters to be transferred to the transmitters (see page 29). It is vital to observe the notes on frequency selection on page 31.

To transfer the parameters:

￿Switch the transmitter and the receiver on.

￿Press the button ￿ on the receiver.

“Sync” appears on the display panel of the receiver.

￿Place the infra-red interface of the transmitter (see the instruction manual of the trans- mitter) in front of the infra-red interface ￿ of the receiver.

The parameters are transferred to the transmitter. When the transfer is completed, “” appears on the receiver’s display panel. The receiver then switches back to the current

standard display.

To cancel the transfer:

￿Press the STANDBY button ￿ on the receiver.

“” appears on the display panel of the receiver. “” also appears if no suitable trans- mitter was found.

40

PEAK B.Ch: 20.64

**2000**

0

 

20

 

-20

 

 

 

543.200MHz

30

 

-10

 

 

 

 

 

 

 

 

 

 

 

 

 

EQ:

 

 

 

 

 

10

 

-30

 

 

 

 

SKM2000

 

 

 

 

 

-40

 

 

 

 

 

 

 

 

P

+ 12dB

MUTE

 

RF

 

AF

 

 

Deactivating the lock mode temporarily

You can activate or deactivate the automatic lock mode via the “Auto Lock” menu item (see page 25).

If the lock mode is activated, you have to temporarily deactivate it in order to be able to operate the receiver:

￿ Press the jog dial or the STANDBY button. “Locked” appears on the standard display.

￿ Turn the jog dial.

“Unlock?” appears on the display panel.

￿ Press the jog dial.

The lock mode is temporarily deactivated.

–When you are in the operating menu, the lock mode remains deactivated until you exit the operating menu.

–When one of the standard displays is shown, the lock mode is automatically activated after 10 seconds.

The lock mode icon flashes prior to the lock mode being activated again.

15