If a problem occurs ...
If a problem occurs ...
Sound problems
Problem | Possible cause | Possible solutions | Page |
No sound | Transmitter is/headphones | Switch the | 19/21 |
| are switched off | transmitter/ |
|
|
| headphones on |
|
| Headphones are muted | Cancel the muting | 22 |
| Jack plug is not properly | Check the plug | 12 |
| connected | connection |
|
| Sound source is switched | Switch the sound | – |
| off | source on |
|
| Audio cable is defective | Replace the cable | – |
| Transmission between | Associate the | 25 |
| transmitter and | headphones with the |
|
| headphones is disturbed | transmitter again |
|
| by interferences (including | Disconnect the | 16 |
| ESD) in the vicinity | transmitter from the |
|
|
|
| |
|
| mains and reconnect |
|
|
| it again |
|
|
| Remove the | 17 |
|
| rechargeable |
|
|
| batteries from the |
|
|
| headphones and |
|
|
| reinsert them again |
|
| Headphones are not | Associate the | 25 |
| correctly associated with | headphones with the |
|
| the transmitter (e.g. | transmitter |
|
| additional headphones) |
|
|
|
|
|
|
Occasional | Headphones are out of | Reduce the distance | 11 |
sound | range | between |
|
dropouts |
| headphones and |
|
|
| transmitter |
|
| Signal is shielded | Remove obstacles | 11 |
|
| between transmitter |
|
|
| and headphones |
|
| Interfering devices in the | Change your position | 11 |
| vicinity |
|
|
|
|
|
|
Sound is too | Volume of the sound | Increase the volume | – |
low | source is adjusted too low | of the sound source |
|
| Signal of the sound source | Set the ATTENUATOR | 13 |
| is too weak | switch to |
|
|
| “0 dB” |
|
| Headphone volume is | Increase the volume | 22 |
| adjusted too low | by pressing the |
|
|
| VOLUME + button |
|
|
|
|
|
Sound only | Audio cable is defective | Replace the audio | – |
on one ear |
| cable |
|
| Audio cable is not properly | Check the plug | 12 |
| connected | connection |
|
|
|
|
|
30