Sennheiser HMEC 460 manual To connect the headset via an adapter cable

To connect the headset via an adapter cable:

￿ Connect the XLR-3 plug of the headset to the XLR-3 socket of the adapter cable.

￿Connect the plug or right-angled jack plug of the adapter cable to the cigarette lighter socket.

Powering the NoiseGard electronics via two (rechargeable) batteries

￿ Open the cover of the battery compartment on the operating control.

￿Insert two 1.5 V AA alkaline-manganese batteries (IEC LR 6) or two 1.2 V AA NiMH rechargeable batteries. Observe correct polarity.

￿ Close the cover of the battery compartment .

With NoiseGard switched on (see “Switching NoiseGard on/off” on page 21), the LED provides information on the remaining battery/rechargeable battery capacity.

LED	lights up yellow:	The battery capacity is sufficient.
LED	lights up red:	The batteries are flat. Replace the batteries.

If the battery voltage is too low, NoiseGard automatically switches off to protect the batteries from total discharge and leakage.

￿Replace the batteries or recharge the rechargeable batteries.

12