HOOKING UP THE AUDIOLlNI(TM

TRANSMITTER/BATTERY CHARGER T-100 TO YOUR TV

1.Insert the two pin power cable into the two pin receptacle on

the transmitter. Plug the other end of the adapter into a 11OV AC wall outlet.

2.Insert the three pin audio cable into the three pin receptacle on the transmitter. Insert the RCA plug into the audio output jack on your VCR, TeleCaptionTM4000 closed caption decoder, hi-fi equipment, or TV. With this connection, volume on the TV is independent of volume on the headset, so all household members can view TV together at a comfortable level.

3.If you prefer to use a headphone jack on your TV or audio equipment, use the appropriate adapter. NCI supplies an RCA to 1/8" mono adapter, which fits most TV headphone jacks. If your audio equipment uses a different jack, consult your audio

equipment owner'smanual. The appropriate adapter is avail- able at most electronics stores.

4.Insert the two batteries into the battery receptacles. In doing so, you will replace the "dummy" battery in one of the recep- tacles. When inserting batteries, observe the guides on the

charger. Make sure each battery is fully inserted, but do not force.

5.If you do not have an audio output jack or headphone jack available, or if you have problems connecting the transmitter, contact your AudioLinkTMdealer or NCI.

Telecaption 4000

Decoder (rear)

rr;1

~p

TV

LOCATION AND USE OF CONTROLS

AUDIOLlNI(TMTRANSMITTER/BATTERY CHARGERT-100

1.LED: Keep these five light emitting diodes (LEDs) unobstructed and in clear line of sight of the LED on the headset.

2.BATTERYRECEPTACLES:Tworechargingportsfor BA-gObatteries.

3.BATTERIES: Two rechargeable batteries each provide ten hours of continuous use when properly charged.

CHARGING THE BATTERIES

-Before first use of the headset, each battery should be charged for 24 hours for optimal use.

-Subsequent recharging time is 12-18 hours. For best results, periodically let each battery drain completely and then re- charge. Because two batteries have been provided, one always can be recharging while the other is in use.

-Batteries are charged as long as the transmitter is plugged in- to an AC outlet. You cannot overcharge the batteries.